DOWNLOAD Panasonic KV-S8147 / KV-S8127 / KV-S8150 / KV-S8130 / KV-S8120 Service Manual ↓ Size: 31.91 MB | Pages: 127 in PDF or view online for FREE

6

1. Unplug the power cord and short the two prongs of the plug with a jumper wire.
2. Turn on the power switch.
3. Measure the resistance value with ohmmeter between the jumpered AC plug and each exposed metal cabinet part, such as

screw threads, control shafts, handle brackets, etc.
Note:

Some exposed parts may be isolated from the chassis by design. These will read infinity.

4. If the measurement is outside the specified limits, there is a possibility of shock hazard. The equipment should be repaired

and rechecked before it is returned to the customer.

7

For safety, before closing the lower cabinet, please make sure of the following precautions.

1. The earth lead is fixed with the screw.
2. The AC connector is connected properly.

Screw

Terminal of Harness
Washer
Power Box Plate

1. Die Erdleitung ist mit der Schraube befestigt.

2. Der Wechselstromanschluss ist korrekt angeschlossen.

Treffen Sie zur Sicherheit folgende Vorsichtsmaßnahmen, bevor Sie das untere Fach schließen. 

Schraube

Anschluss des Kabelstrangs
Unterlegscheibe
Power Box Platte

8

The power socket wall outlet should be located near this equipment and be easily accessible.

In the information below, Pb, the symbol for lead in the periodic table of elements, will refer to standard solder or solder that con-
tains lead.
We will use PbF when discussing the lead free solder used in our manufacturing process which is made from Tin, (Sn), Silver,
(Ag), and Copper, (Cu).
This model, and others like it, manufactured using lead free solder will have PbF stamped on the PCB. For service and repair
work we suggest using the same type of solder. 

• PbF solder has a melting point that is 50° ~ 70° F, (30° ~ 40°C) higher than Pb solder. Please use a soldering iron with tempera-

ture control and adjust it to 700° ± 20° F, (370° ± 10°C). 
Exercise care while using higher temperature soldering irons.
Do not heat the PCB for too long time in order to prevent solder splash or damage to the PCB.

• PbF solder will tend to splash if it is heated much higher than its melting point, approximately 1100°F, (600°C).
• When applying PbF solder to double layered boards, please check the component side for excess which may flow onto the

opposite side (See figure, below).

9

There are several types of PbF solder available commercially. While this product is manufactured using Tin, Silver, and Copper,
(Sn+Ag+Cu), you can also use Tin and Copper, (Sn+Cu), or Tin, Zinc, and Bismuth, (Sn+Zn+Bi). Please check the manufac
turer's specific instructions for the melting points of their products and any precautions for using their product with other 
materials. 
The following lead free (PbF) solder wire sizes are recommended for service of this product: 0.3mm, 0.6mm and 1.0mm.