Panasonic KV-S4065CL / KV-S4065CW / KV-S4065CWCN / KV-S4085CL / KV-S4085CW / KV-S4085CWCN (serv.man2) Service Manual / Supplement ▷ View online
4
(5) Release the hook to remove the Panel Cover from the Right
Cover.
Cover.
(6) Remove the connector to the Panel Cover to release
the Right Cover from the scanner.
the Right Cover from the scanner.
Reassembling Note:
Before reassembling the Right Cover, make sure
to close the Front Door first.
(The procedure of closing Front Door after
attaching the Right Cover may cause the bundle
of the wires to be pulled and pinched.)
to close the Front Door first.
(The procedure of closing Front Door after
attaching the Right Cover may cause the bundle
of the wires to be pulled and pinched.)
5
2.1.2.
"Section 8.2.3 Post-imprinter Door (Imprinter Cover)"
(1) Open the Post-imprinter Door.
(2) In the direction of the arrow, pull the right tip of the
Post-imprinter Door along the groove.
Then pull the left tip of the Post-imprinter Door
backward to remove the door.
Post-imprinter Door along the groove.
Then pull the left tip of the Post-imprinter Door
backward to remove the door.
6
2.2.
"Section 8.4 Board Assembly"
2.2.1.
"Section 8.4.1 CONTROL Board and DRIVE Board"
(1) Remove the Right Cover. (See 8.2.1.)
(2) Remove the screw (a), screw (b), and 2 screws (c) from the
back.
back.
(3) Remove the screw from the right.
(4) Release the connector wires from the 3 wire clamps.
(5) Pull out the Board Plate Assembly after releasing the
connector wires from the 5 wire clamps.
(5) Pull out the Board Plate Assembly after releasing the
connector wires from the 5 wire clamps.
Reassembling Note:
Make sure to fasten the cables with the clamper
so that the bundle of single-wire is located on the
multi-wire cables (Shield cable and gray color
cable).
so that the bundle of single-wire is located on the
multi-wire cables (Shield cable and gray color
cable).
7
3 “SECTION 9 SERVICE UTILITY & SELF TEST”
3.1.
“Section 9.3 Operation”
3.1.1.
“Section 9.3.1 Scanner Status”