Panasonic NN-GT352WZPE Service Manual ▷ View online
2-1
• DO NOT operate on a 2-wire extension cord during
repair and use.
• NEVER TOUCH any oven components or wiring during
operation.
• BEFORE TOUCHING any parts of the oven, always
remove the power plug from the outlet.
• For about 30 seconds after the oven stops, an electric
charge remains in the high voltage capacitor. When
replacing or checking, you must discharge the high
voltage capacitor by shorting across the two terminals
with an insulated screwdriver.
replacing or checking, you must discharge the high
voltage capacitor by shorting across the two terminals
with an insulated screwdriver.
•
Remove your watches whenever working close to or
replacing the Magnetron.
• NEVER operate the oven with no load.
• NEVER injure the door seal and front plate of the oven
• NEVER injure the door seal and front plate of the oven
cavity.
• NEVER put iron tools on the magnetron.
• NEVER put anything into the latch hole and the
• NEVER put anything into the latch hole and the
interlock switches area.
• Proper operation of the microwave oven requires that
the magnetron be assembled to the waveguide and
cavity. Never operate the magnetron unless it is
properly installed.
cavity. Never operate the magnetron unless it is
properly installed.
• Be sure that the magnetron gasket is properly
installed around the dome of the tube whenever
installing the magnetron.
installing the magnetron.
CAUTIONS
Unlike other appliances, the microwave oven is
high-voltage and high-current equipment.
Though it is free from danger in ordinary use,
extreme care should be taken during repair.
high-voltage and high-current equipment.
Though it is free from danger in ordinary use,
extreme care should be taken during repair.
THE OVEN IS TO BE SERVICED ONLY
BY PROPERLY QUALIFIED SERVICE
PERSONNEL.
BY PROPERLY QUALIFIED SERVICE
PERSONNEL.
MICROWAVE RADIATION
Personnel should not be exposed to the
microwave energy which may radiate from the
magnetron or other microwave generating
device if it is improperly used or connection.
All input and output microwave connections,
waveguide, flange and gasket must be secure
never operate the device without a microwave
energy absorbing load attached.
Never look into an open waveguide or antenna
while the device is energized.
microwave energy which may radiate from the
magnetron or other microwave generating
device if it is improperly used or connection.
All input and output microwave connections,
waveguide, flange and gasket must be secure
never operate the device without a microwave
energy absorbing load attached.
Never look into an open waveguide or antenna
while the device is energized.
ANTENNA
COOLING FIN
MAGNETRON
CHASSIS GROUND
CHASSIS GROUND
FILAMENT
TERMINALS
TERMINALS
MAGNETRON
GASKET
3-1
INSTALLATIONS
INSTALLING
1. Empty the microwave oven and clean inside it with
a soft, damp cloth. Check for damage such as
misaligned door, damage around the door or dents
inside the cavity or on the exterior.
misaligned door, damage around the door or dents
inside the cavity or on the exterior.
2. Put the oven on a counter, table, or shelf that is
strong enough to hold the oven and the food and
utensils you put in it. (The control panel side of the
oven is the heavy side. Use care when handling.)
utensils you put in it. (The control panel side of the
oven is the heavy side. Use care when handling.)
3. Do not block the vent and the air intake openings.
Blocking vent or air intake openings can cause
damage to the oven and poor cooking results.
Make sure the microwave oven legs are in place to
ensure proper air flow.
damage to the oven and poor cooking results.
Make sure the microwave oven legs are in place to
ensure proper air flow.
4. The oven should not be installed in any area where
heat and steam are generated, because they may
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.
5. Use microwave oven in an ambient temperature
less than 104°F(40°C).
6. Place the microwave oven on a sturdy and flat
surface at least 10 cm(4 inches) from the wall.
7. Place the microwave oven as far away as possible
from TV, RADIO, COMPUTER, etc., to prevent
interference.
interference.
EARTHING INSTRUCTIONS
This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing
WARNING-
THIS APPLIANCE
MUST BE EARTHED
THIS APPLIANCE
MUST BE EARTHED
IMPORTANT
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
The wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol ( ) or
colored green or green-and-yellow.
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol ( ) or
colored green or green-and-yellow.
The wire which is colored blue must be connected to
the terminal in the plug which is marked with the letter
N or colored black.
the terminal in the plug which is marked with the letter
N or colored black.
The wire which is colored brown must be connected
to the terminal in the plug which is marked with the
letter L or colored red.
to the terminal in the plug which is marked with the
letter L or colored red.
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
10cm
The wires in this mains lead are colored in
accordance with the following code:
accordance with the following code:
Green-and-yellow:
Earth
Blue:
Neutral
Brown:
Live
4-1
OPERATING INSTRUCTIONS
FEATURES
CONTROL PANEL
Roller Ring
Oven Front Plate
Door C
Safety Door Lock System
Control Panel
Glass Tray
See-Through oven window
Wire Rack
(1) Display Window
(2) Time Pads
(3) Micro Power Pad
(4) Grill Pad
(5) Combi Pad
(6) Turbo Defrost Pad
(7) Timer/Clock Pad
(8) Auto Cook Pads
(9) Stop/Reset Pad
(2) Time Pads
(3) Micro Power Pad
(4) Grill Pad
(5) Combi Pad
(6) Turbo Defrost Pad
(7) Timer/Clock Pad
(8) Auto Cook Pads
(9) Stop/Reset Pad
Before cooking: One tap clears your instructions.
During cooking: One tap temporarily stops the cooking
During cooking: One tap temporarily stops the cooking
appears in the Display Window.
(10) Start Pad
One tap allows oven to begin functioning. If door is opened
Start Pad must be pressed again to restart oven.
Micro Power Pad
Grill Pad
Combi Pad
Time Pads
Grill Pad
Combi Pad
Time Pads
process. Another tap cancels all your instructions and
colon
colon
or Stop/Reset Pad is pressed once during oven operation,
NN- GT352W(ZPE)
Beep Sound:
When a pad is pressed correctly, a beep will be heard.
If a pad is pressed and no beep is heard, the unit did
When a pad is pressed correctly, a beep will be heard.
If a pad is pressed and no beep is heard, the unit did
programmed stages. At the end of any
not or cannot accept the instruction. The oven will beep
twice between
complete program, the oven will beep 5 times.
(1)
(2)
(5)
(3)
(6)
(8)
(9)
(4)
(7)
(10)
4-2
The following is a description of component functions
during oven operation.
during oven operation.
1. SETTING THE CLOCK
NOTE: This is a 24 hour clock.
2. CANCEL FUNCTION
Touch the S
/Cancel pad whenever you need to
cancel an entry or a function currently in use.
The display will either return to the last item entered
or to the clock.
The display will either return to the last item entered
or to the clock.
3. MICROWAVE COOKING
4. GRILL COOKING
5. COMBI COOKING
TIME
START
Stop/Cancel
TIME
START
TIME
START
6. AUTO DEFROST COOKING
Stop/
Clock
Set the time
by pressing
time pads
time pads
Clock
Desired
defrost
Desired
Start
program
weight
7. CHILD SAFETY LOCK
OPERATING SEQUENCE
Using this system will make the oven inoperable; however,
the door can be opened.Child Lock can be set when the
display shows a colon or the time.
Press Start Pad three times in 10 seconds.
The time of the day will disappear.
Actual time will not be lost.
Actual time will not be lost.
'L---' is indicated in the display.
To Cancel
Press Stop/Cancel Pad three times in 10 second
The time of day will reappear in the display.
TO Set
Reset
top
Stop/
Stop/Cancel
Stop/Cancel
Cancel
Start
Stop/ Cancel
Click on the first or last page to see other NN-GT352WZPE service manuals if exist.