Panasonic MC-CL675-ZC79 / MC-CL675-ZA76 / MC-CL673-SC79 / MC-CL673-SA76 / MC-CL671-RC79 / MC-CL671-RA76 / MC-CL671RR79 / MC-CL673SR79 Service Manual ▷ View online
9
5. Disconnect the fast-on terminal of the lead wire connect-
ing the fan motor unit to the P.C.B. assy.
* When connecting or disconnecting the fast-on ter-
* When connecting or disconnecting the fast-on ter-
minal, hold the P.C.B. assy and connecting terminals.
6. Disconnect the fast-on terminal of the lead wire connect-
ing the P.C.B. assy to the body partition assy.
* MC-CL675
* MC-CL675
* MC-CL673, CL671
4.3.
Motor removal
1. Remove the P.C.B. holder from the lower body.
2. Remove the motor set from the lower body.
10
3. Remove all components fitted to the fan motor unit.
a. Remove the motor support rubber (rear).
b. Remove the motor support.
b. Remove the motor support.
c. Remove the noise absorber.
d. Remove the motor support rubber (front).
* MC-CL675
* MC-CL673, CL671
4.4.
Cord reel unit replacement
1. Lift the body partition assy (fitted with the cord reel unit)
while removing the cord reel shaft from the side of the
lower body.
lower body.
11
2. Remove the screw fixing the body partition assy and the
cord reel unit.
3. Remove the cord reel unit from the body partition assy.
4.5.
Spring-loaded cord reel pre-
winding
winding
1. The body partition assy has a spring that pre-winds the
cord reel.
If the cord is not wound, then press the brake lever unit,
and the cord pre-winding will be loosened.
Pre-wind the cord as indicated by the arrow mark.
Number of pre-windings: Four turns
If the cord is not wound, then press the brake lever unit,
and the cord pre-winding will be loosened.
Pre-wind the cord as indicated by the arrow mark.
Number of pre-windings: Four turns
* If you wish to release the pre-winding, then make
sure to hold the cord plug.
4.6.
Installation of some Pakkin
1. Remove the two screws fixing the lower and front bodies.
2. Remove the front body from the lower body.
12
4.7.
How to disassemble the tur-
bine nozzle
bine nozzle
4.7.1.
Agitator ass'y
1. Rotate the Lock on the brush cover to unlock and remove
the brush cover U.
2. Pull up the agitator ass'y and remove the belt and agitator
ass'y (complete). (Fig.26)
4.7.2.
Separation of the floor nozzle
upper U from the floor nozzle
lower U
upper U from the floor nozzle
lower U
1. Remove the four screws fixing the floor nozzle lower U.
(Fig.27)
2. Remove the floor nozzle lower U.
4.7.3.
Turbine Ass'y
1. Pull up the floor nozzle wand U and remove the turbine
ass'y. (Fig.28)
Click on the first or last page to see other MC-CL675-ZC79 / MC-CL675-ZA76 / MC-CL673-SC79 / MC-CL673-SA76 / MC-CL671-RC79 / MC-CL671-RA76 / MC-CL671RR79 / MC-CL673SR79 service manuals if exist.