DOWNLOAD Panasonic MC-CG663ZR79 / MC-CG661KR79 Service Manual ↓ Size: 1.16 MB | Pages: 18 in PDF or view online for FREE

9

6. Remove all components fitted to the motor.

a. Remove the motor support rubber (rear).
b. Remove the motor support.

c. Remove the noise suppressor.

d. Remove the motor support rubber (front).
e. Remove the lead wires connected to the motor.

1. Increase the gap width between the cord reel and the

lower body with a screwdriver. While removing the cord
reel shaft from the side of the lower body, lift the cord reel
partition unit.

10

1. Remove the screw fixing the rail base U onto the cord reel

partition U.

2. Remove the rail base U from the cord reel partition U.

1. The cord reel partition U has a spring that pre-winds the

cord reel.
If the cord is not wound, then press the brake arm, and
the cord pre-winding will be loosened.
If you wish to apply pre-winding again, then wind the cord
three turns in the direction of the arrow mark.
* If you wish to release the pre-winding, then make 

1. Rotate the brush cover to unlock it and remove the brush

cover U.

2. Pull up the rotating brush and remove the belt and rotat-

ing brush (complete). (Fig.19)

1. Remove the four screws fixing the floor nozzle lower U.

(Fig.20)

2. Remove the floor nozzle lower U.

11

1. Pull up the floor nozzle pipe U and remove the turbine

complete. (Fig.21)

1. Turn the floor nozzle lower unit over. Insert the tip of a

flat-blade screwdriver into one side of the brush, then
remove the brush.(Fig.22)

12