Panasonic EW1611W520 Service Manual ▷ View online
ORDER NO. BLGZ1809W3CE
Oral Irrigator
Model No.
EW1611
America
Russia
Australia
TABLE OF CONTENTS
Page
Page
1 WARNING............................................................................ 2
4 DISASSEMBLY/ASSEMBLY INSTRUCTIONS .................. 4
2 SPECIFICATIONS ............................................................... 2
5 EXPLODED VIEW & REPLACEMENT PARTS LIST ......... 6
3 TROUBLESHOOTING GUIDE ........................................... 3
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typically the melting point is 422-424°F (217 - 218°C) higher.
Please use a soldering iron with temperature control and adjust it to 680 ± 36°F (360 ± 20°C). In case of using high temperature
solder- ing iron, please be careful not to heat too long.
solder- ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100°F / 400°C).
2 Specifications
Power Source
AC 100 - 240 V 50 - 60 Hz
Power consumption
18 W
Water tank volume
Approx. 600 mL (the water pressure level “10”, 115 seconds)
Dimensions
Main unit:
280 (H) × 125 (W) × 140 (D) mm (Including nozzle)
200 (H) × 125 (W) × 140 (D) mm (Not including nozzle)
280 (H) × 125 (W) × 140 (D) mm (Including nozzle)
200 (H) × 125 (W) × 140 (D) mm (Not including nozzle)
Suction hose length
Approx. 1100 mm
Mass
Main unit: Approx. 940 g (Including nozzle)
3
3 Troubleshooting Guide
4
4 Disassembly and Assembly Instructions
4.1.
Disassembly and Assembly
Instructions
Instructions
1. Remove the tank.
2. Remove 2 screws, and remove the handle and the stor-
age case for hose.
*Be careful not to lose the O-ring.
*Be careful not to lose the O-ring.
*In assembly, insert the Suction hose joint firmly before
fastening the screw so as to prevent the water leakage.
fastening the screw so as to prevent the water leakage.
3. Remove the top lid of housing by inserting the slotted-
screwdriver unhooking 8 hooks.
4. Remove 2 screws, and then remove the middle lid of
housing.
*Be careful not to lose the O-ring.
*Be careful not to lose the O-ring.
5. Remove the switch buttons.
6. Remove 1 screw, and then remove the power cord plate.
7. Remove 5 screws, and then remove the bottom cover
7. Remove 5 screws, and then remove the bottom cover
assembly.
Display