Panasonic EW-DL82-W820 Service Manual ▷ View online
Order Number SD1311X41CE
Sonic Vibration Toothbrush
Model No.
EW-DL82
Europe
CIS
CIS
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 5
5 Schematic Diagram ---------------------------------------------- 9
6 Exploded View and Replacement Parts List -----------10
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 5
5 Schematic Diagram ---------------------------------------------- 9
6 Exploded View and Replacement Parts List -----------10
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70
°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
3.1.
Main unit and charging adaptor
4
3.2.
After reparing
1. Confirm the smooth and normal operation when switching ON.
2. Confirm if the charging status lamp is lit when connecting the main unit with charger.
3. Confirm if the water-proof rubber is assembled without any pinching.
4. Confirm if there is no abnormal sound.
2. Confirm if the charging status lamp is lit when connecting the main unit with charger.
3. Confirm if the water-proof rubber is assembled without any pinching.
4. Confirm if there is no abnormal sound.
NOTE:
1. When the rechargeable battery is replaced, charge the main unit onto charger. The main PCB may not operate until the charg-
ing current flows.
2. The charge status lamp may not be lid if the battery is completely discharged.
3. If the main unit set on the charger with switching ON, the operation stops and start charging.
4. The battery capacity lamp may blink if the switch turns ON after replacing the battery. It is not failure. The charge status lamp
3. If the main unit set on the charger with switching ON, the operation stops and start charging.
4. The battery capacity lamp may blink if the switch turns ON after replacing the battery. It is not failure. The charge status lamp
will turn off when charging is completed.