Panasonic ES8043-E8 / ES8044-E8 Service Manual ▷ View online
1 SCHEMATIC DIAGRAM
2
2 DISASSEMBLY INSTRUCTIONS
3
3 ASSEMBLY INSTRUCTIONS
5
2005 Works,
. and is a
of .
. and is a
of .
ES8043-E8
ES8044-E8
ES8044-E8
4 TROUBLESHOOTING GUIDE
7
5 EXPLODED VIEW & REPLACEMENT PARTS LIST
9
Wet/Dry Rechargeable Shaver
SPECIFICATIONS
Power source
AC 100-240V, 50-60Hz (Automatic voltage conversion)
Power consumption
Approx. 5W
Motor voltage
3.6V DC
Charging time
1 Hour
Shaves per charge
14 times (3 minutes shave)
Measurement
(H)15.3 x (W)6.2 x (D)4.6 cm
Weight
180g (without protective cap)
Supplied accessories
Soft case
Cleaning brush
CONTENTS
Page
Page
ORDER NO. SD0506E38C8
1 SCHEMATIC DIAGRAM
1.1. ES8043
1.2. ES8044
2
ES8043-E8 / ES8044-E8
Follow the procedure below to disassemble the main unit.
1. Remove the cap, the outer foil with foil frame and the
inner blade.
2. To remove the trimmer driving bar or the slit blade
driving bar, press bars outward.
3. Loosen a screw and remove the bottom cover. Set the
pivot action selector to "LOCK". Slide the rear panel and
remove it with care of pivot action selector.
remove it with care of pivot action selector.
4. Remove the both side of housing clips.
Loosen four screws and remove housing B.
Take out the lock lever shaft.
Take out the lock lever shaft.
5. Slide the trimmer handle up to open the trimmer and
unhook 2 locations on both side by inserting the slit with
something like a slotted-head screw driver.
something like a slotted-head screw driver.
2 DISASSEMBLY INSTRUCTIONS
3
ES8043-E8 / ES8044-E8
6. Remove trimmer and trimmer handle.
7. Move gently the linear motor assembly down and
unhook it and remove the float springs from housing A.
8. Pull up the battery and chassis block from the linear
motor side first. Then, slide it upward and take it out
from the housing A.
NOTE:
from the housing A.
NOTE:
Do not pull the battery and chassis block forcefully
due to connecting the linear motor by the lead wires.
due to connecting the linear motor by the lead wires.
9. Take out the battery from the chassis.
10. Unsolder the lead wires from the module.
4
ES8043-E8 / ES8044-E8