Panasonic ES2054 / ES2057 Service Manual ▷ View online
Order Number PCD0704E32CE
Epilator
Model No. ES2054/
ES2057
ES2057
Europe
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 6
6 Schematic Diagram ---------------------------------------------- 6
7 Exploded View and Replacement Parts List ------------ 7
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 6
6 Schematic Diagram ---------------------------------------------- 6
7 Exploded View and Replacement Parts List ------------ 7
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70
°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
4
4 Disassembly and Assembly Instructions
Follow the procedure below to disassemble the main unit.
4.1.
Disassembly Instructions
[MAIN UNIT]
Follow the procedure below to disassemble the main body.
1. Remove the cap and the epilation head.
Loosen three screws on top.
2. Remove the head mounting base, side panel, switch,
switch cam and head release button. Remove the chassis
with pushing a head release button.
with pushing a head release button.
3. Loosen two screws and take out the plug block with using
the plug remove jig.
Insert the jig and push into the plug connector and take it
out.
Insert the jig and push into the plug connector and take it
out.
