DOWNLOAD Panasonic ES-LV95-S820 / ES-LV65-S820 Service Manual ↓ Size: 715.08 KB | Pages: 17 in PDF or view online for FREE

9

5. Take out the battery from the chassis.

6. Unsolder the lead wires from the module.

7. Loosen two screws.

8. Move gently the linear motor assembly down and unhook

it and remove the float springs from housing A. 

10

When reassembling, replace the new waterproof seal.
Make sure whether there is NO foreign substance sticking
around a part covered with waterproof seal.

1. Solder the lead wires with the module.

Make sure of the color of lead wires.

2. Attach the tube holder.  Tighten two screws between the

linear motor assembly and the housing A.

3. When inserting the module and chassis block into the

housing A, confirm if the module does not get any dam-
age or deformation.

4. Make sure that the lead wires set in position to avoid

abnormal noise. Install (+) terminal of battery into the ter-
minal plate at the bottom cover side and firmly set the bat-
tery sliding the direction of arrow.  Attach (-) terminal of
battery.
NOTE:

Once taking the battery out, the shaver is RESET.
The shaver must be charged for about 10 seconds
first.

Completely discharge and then fully charge before
returning the shaver to the customer.

11

5. When putting the housing A and the housing B together,

make sure if the waterproof seal must be fitted properly
and no foreign substance sticking around.

6. Tighten six screws and attach the rear panel firmly. 

12

7. Attach the bottom cover and tighten a screw.

8. Set the trimmer driving bar, the finishing blade driving bar

and the slit blade driving bar.