Panasonic ER217-E2 Service Manual ▷ View online
1 SCHEMATIC DIAGRAM
2
2 WIRING CONNECTION DIAGRAM
2
3 DISASSEMBLY INSTRUCTIONS
3
4 ASSEMBLY INSTRUCTIONS
5
2006 Works,
. and is a
of .
. and is a
of .
ER217-E2
5 TROUBLESHOOTING GUIDE
7
6 EXPLODED VIEW
8
7 REPLACEMENT PARTS LIST
9
AC/Rechargeable Beard/Hair Trimmer
SPECIFICATIONS
CONTENTS
Page
Page
ORDER NO. SD0604E33CE
1 SCHEMATIC DIAGRAM
2 WIRING CONNECTION DIAGRAM
2
ER217-E2
1. Remove the attachment and blade.
2. Loosen a screw and remove the bottom cover.
3. Insert a slotted-head screw driver (less than 2.4mm width
on top) into the slit of dial cover and raise it with the driver.
NOTE: Make sure there is NO scratch or damage on the
parts.
NOTE: Make sure there is NO scratch or damage on the
parts.
4. Loosen a screw and take out the dial mounting base, the
trimming length indicator ring with the dial.
5. Loosen two screws tightening the blade spring.
3 DISASSEMBLY INSTRUCTIONS
Follow the procedure below to disassemble the main body.
3
ER217-E2
6. To separate the housing C and B, insert a slotted-head
screw driver into the slit of housing.
Raise the housing C with the driver slightly and open the
housings with hand slowly.
NOTE: In case of the housings can not be opened,
insert the driver further (depth to the lamp cover).
Raise the housing C with the driver slightly and open the
housings with hand slowly.
NOTE: In case of the housings can not be opened,
insert the driver further (depth to the lamp cover).
7. Loosen two screws on both top and bottom of housing A.
And remove the housing A after loosing six screws.
8. Take out the motor, module and battery assembly from
housing A.
9. Take out the rechargeable battery from the battery holder
and the motor from the motor holder.
4
ER217-E2