Panasonic ER-GC20 / ER-GC20-K520 Service Manual ▷ View online
Order Number SD1108E60CE
Hair Clipper
Model No.
ER-GC20
Europe
CIS
CIS
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly Instructions ------------------------------------- 4
5 Wiring Connection Diagram ---------------------------------- 5
6 Schematic Diagram ---------------------------------------------- 5
7 Exploded View and Replacement Parts List ------------ 6
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly Instructions ------------------------------------- 4
5 Wiring Connection Diagram ---------------------------------- 5
6 Schematic Diagram ---------------------------------------------- 5
7 Exploded View and Replacement Parts List ------------ 6
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70
°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
(Refer to Wiring Connection Diagram)
4
4 Disassembly Instructions
1. Remove the attachment and the blade.
2. Loosen two screws tightening the blade springs and one
2. Loosen two screws tightening the blade springs and one
housing screw on bottom.
3. Take out the housing C.
4. Loosen eight screws tightening the housing B and sepa-
4. Loosen eight screws tightening the housing B and sepa-
rate the housing A and B.
5. Loosen two screws tightening the motor holder at the
upside of housing B and remove the motor block.
Display