Panasonic EH-NE50 Service Manual ▷ View online
5
4 Disassembly and Assembly Instructions
4.1.
Disassembly Instructions
1. Remove the nozzle from the main body.
2. Unfasten the screw on the housing and remove the air
outlet ring with the outer grill by rotating counter clock-
wise.
wise.
3. Unfasten two Torx screws on the handle and remove the
handle and the electrification panel.
4. To disassemble the housing, insert the small slotted
screwdriver at bottom of the housing. Then remove the
housing A.
housing A.
6
4.2.
Caution In Assembly
Refer to WIRING DIAGRAM to solder the wires
1. Confirm that the polyester tapes are stuck on the heater
motor block as shown in the following figure.
2. Confirm that there are the aluminum seals (6.0x6.0) on
the both discharge cover, before installing the discharge
electrodes between the ribs.
electrodes between the ribs.
3. Allocate the lead wires between the ribs on the housing B
as shown in the following figure. Then stick the polyester
tape (20.0x70.0) over the lead wires.
tape (20.0x70.0) over the lead wires.
4. Confirm that there is the polyester tape on the igniter until
the back from the capacitor surface.
7
5. Attach the heater motor block to housing B by installing
the plates between the ribs.
6. Install the high voltage block to housing B and allocate
the lead wires as shown in the following.
a. Allocate the all lead wires between the ribs.
b. Arrange the lead wires over the black insulation tube.
b. Arrange the lead wires over the black insulation tube.
c. Allocate the all lead wires underneath the plate.
7. Allocate the switch block and insulation tube of the power
cord on the handle.
a. Insert the switch plates between the switches by fitting
the hole of the switch plate to the plate of the switch.
b. Allocate the gray insulation tube of the power cord to
over the following line A-A.
8
8. Allocate the capacitor and PCB on the electrification
panel, then arrange the lead wire and insulation tube as
shown in the following. Stick the aluminum seal
(20.0x9.0) over the tip of white lead wire.
shown in the following. Stick the aluminum seal
(20.0x9.0) over the tip of white lead wire.
9. Insert the swivel ring to the housing so that the marking
points downward.
Click on the first or last page to see other EH-NE50 service manuals if exist.