Panasonic EH-HW17 Service Manual ▷ View online
Order Number PEWT1207E37CE
Compact Multi Straightener
Model No.
EH-HW17
Russia
CIS
CIS
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
4.1. Disassembly Instructions -------------------------------- 4
4.2. Assembly Instructions ------------------------------------ 6
4.2. Assembly Instructions ------------------------------------ 6
5 Wiring Connection Diagram ---------------------------------- 7
6 Schematic Diagram ---------------------------------------------- 8
7 Exploded View and Replacement Parts List ------------ 9
6 Schematic Diagram ---------------------------------------------- 8
7 Exploded View and Replacement Parts List ------------ 9
7.1. Exploded View --------------------------------------------- 9
7.2. Replacement Parts List ---------------------------------10
7.2. Replacement Parts List ---------------------------------10
2
1 Warning
Caution:
- Pb free solder has a higher melting point that standard solder Typicall the melting point is 50 - 70
°F (30 - 40°C) a higher.
Please use soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C).
In case of using high temperature soldering iron, please be careful not to heat too long.
- Pb free solder will tend to splash when heated too high (about 1100
- Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
(Refer to SCHEMATIC DIAGRAM)
4
4 Disassembly and Assembly Instructions
4.1.
Disassembly Instructions
1. Insert a small flat head screwdriver into the Groove of the
Shaft Cover as shown in Figure 4.
2. Remove the Shaft screw and take off the Shaft from Main
body as shown in Figure 5.
3. Remove the spring by pull out of the Housing side and
Press plate side as shown in Figure 6.
4. Remove the two tapping screws from the Press Plate
Cover as shown in Figure 7.
Be careful not to lose the spring.
Be careful not to lose the spring.
5. Take off the Press Plate Cover as shown in Figure 8.