DOWNLOAD Panasonic KX-FLB883RU Service Manual ↓ Size: 13.43 MB | Pages: 127 in PDF or view online for FREE

73

(1) Station keys
(2) BROADCAST
(3) MANUAL BROAD
(4) LOWER
(5) COLLATE / DIRECTORY
(6) QUALITY / CONTRAST
(7) ZOOM / RESOLUTION
(8) PAGE LAYOUT / QUICK SCAN
(9) MENU
(10) TONE
(11) STOP
(12) AOH
(13) FAX AUTO ANSWER 
(14) HELP
(15) FAX
(16) COPY
(17) SET
(18) SCAN
(19) Navigator key
(20) REDIAL / PAUSE
(21) FLASH
(22) MONITOR

(23) START

74

The space required to install the unit is shown below.
The dimensions given are necessary for the unit to operate efficiently.

• Avoid excessive heat or humidity.
• Use the unit within the following ranges of temperature and humidity.
• Ambient temperature: 10

°C to 32.5°C

• Relative humidity:   20% to 80% (without condensation)
• Power cord length should be less than 5 meters. Using a longer cord may reduce the voltage or cause malfunctions.
• Avoid direct sunlight.
• Do not install near devices which contain magnets or generate magnetic fields.
• Do not subject the unit to strong physical shock or vibration.
• Keep the unit clean. Dust accumulation can prevent the unit from functioning properly.
• To protect the unit from damage, hold both sides when you move it.
• Do not place the unit in an area where the paper tray may be obstructed (i.e., by a wall, etc.)
• Keep this surface ( ) away from walls etc. more than 50 mm to let the unit cool down.

Insert the document tray (1) into the slot (2) on the unit.

75

As a default setting, printed paper is stacked on the output tray as follows.
- Upper output tray (“#1”): Printed document by using the computer and copied document.
- Lower output tray (“#2”): Received fax document.

• You can change the output tray setting for faxing (feature #441) and for copying (feature #466). To change the output tray from

the computer, set the printer properties.

• The upper output tray can hold up to approximately 100 sheets of printed paper. The lower output tray can hold up to approxi-

mately 50 sheets of printed paper. Remove the printed paper before the output tray becomes full.

• Do not place the unit in an area where the output tray may be easily bumped into.

Insert the output tray (1) into the slots (2), then push the tray down until
it locks into place.

Pull the output tray extender (1) forward gently until it clicks into place,
then press the centre part of the extender (2) to open.

• Repeat from step 1 to install the upper output tray.

76

The paper input tray unit can hold:
— Up to 250 sheets of 60 g/m

2

 to 75 g/m

2

 paper.

— Up to 230 sheets of 80 g/m

2

 paper.

— Up to 200 sheets of 90 g/m

2

 paper.

• The unit is set for printing A4 size paper by default. If you want to use letter or legal size paper, change the setting (feature #380)

: (Refer to Program Mode Table (P.108).)

Pull the paper input tray (1) completely out.

Pinch the front side of the recording paper guide (1), then slide it to
match the paper size mark.
Pinch the both sides of the recording paper guides (2), then slide them
to match the paper size mark.

Before loading a stack of paper, fan the paper to prevent paper jams.