DOWNLOAD Panasonic H-PS14042PP / H-PS14042E / H-PS14042GK Service Manual ↓ Size: 3.49 MB | Pages: 14 in PDF or view online for FREE

9

Proceed disassemble and assemble, by referring the following table Fig. 5-1.
Important:

1. It is recommended dealing with Clean box, to keep maintaining the dustproof environment.

(Refer to “4.2. Clean Box” section of this service manual for detailes.)

2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, keep covering the lens unit with lens caps (front &

rear), other than necessary cases.

3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).

1. When tightening screws, use a torque driver (RFKZ0456) with specified torque mentioned in each step.

Fig. 5-1

10

1. Decoring is sticked on the lens(1).
2. Put the sheet so that the lens glass is fully covered.
3. Insert the needle to Gap (A) (between the Decoring and

lens glass), and peel off the Decoring gently.

1. Align the hole of Decoring and the character "LUMIX G",

and then stick them.

• Use new Decoring. (Do not use the one which is

removed.)After installing the Decoring, press the Decor-
ing with your finger.

11

1. Blow off the dust first, then sweep out the dust from narrower spaces with soft cleaning brush.
2. Wipe up fingerprint and/or dirt on the Outer casing part with the dry fuzz-free cloth.

Define the location of the dust/dirt first, whether it is outside lens surface or not.

1. When it is outside surface of the lens:

• When the dust and/or dirt gets on the outer side surface of the Lens glasses, order the following procedures.

a. Blow off the dust on the Lens glass surface with the Blower, gently. (Do not Blow too strongly.)
b. Wipe out the dirt on the lens glass surface with Lens cleaning KIT(BK) (VFK1900BK) if necessary.

 (Consult the Instruction sheet which is included in the Lens cleaning KIT(BK) in details.)

12