Panasonic H-HS35100PP / H-HS35100E / H-HS35100GK Service Manual ▷ View online
9
4 Disassembly and Assembly Instructions
4.1.
Outline
Proceed disassemble and assemble, by referring the following table and Fig.4-1.
IMPORTANT:
IMPORTANT:
1. It is recommended dealing with Clean box, to keep maintaining the dustproof environment.
(Refer to "3.2. Clean Box" section of this service manual for details.)
2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, keep covering the lens unit with Lens caps (front
& rear), other than necessary cases.
3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
6. When tightening screws, use a Torque driver (RFKZ0456) with specified torque mentioned in each step.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
6. When tightening screws, use a Torque driver (RFKZ0456) with specified torque mentioned in each step.
10
4.2.
Important notice of disassembly and assembly
4.2.1.
About the LENS MOUNT RUBBER
1. Install the LENS MOUNT RUBBER
2. Install the L MOUNT UNIT
11
4.2.2.
About the OIS switch
1. Note when the OIS switch is installed.
Apply "CEMEDINE SUPER X 8008 BLACK" (Commercial item) to the following 2 points after installing the OIS switch.
12
4.3.
Disassembly procedure
Important:
It must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000
(FederalStandard 209D))
(Satisfied clean level: Less than class 10,000
(FederalStandard 209D))
4.3.1.
Removal of the Decoration Ring
1. Decoration ring is stuck on the Lens top unit .
2. Put the sheet so that the lens glass is fully covered.
3. Insert the small flat blade screwdriver to Gap
2. Put the sheet so that the lens glass is fully covered.
3. Insert the small flat blade screwdriver to Gap
(between the decoration ring and lens glass),
and peel off the decoration ring gently.
and peel off the decoration ring gently.
4.3.2.
Removal of the the Lens top unit
1. Remove the 3 screws (A).
4.3.3.
Removal of the 1st lens block
1. Remove the 1st dust proof rubber and the 3 screws (B).
Click on the first or last page to see other H-HS35100PP / H-HS35100E / H-HS35100GK service manuals if exist.