DOWNLOAD Panasonic H-HS12035PP / H-HS12035E / H-HS12035GK Service Manual ↓ Size: 8.41 MB | Pages: 16 in PDF or view online for FREE

9

Proceed disassemble and assemble, by referring the following table and Fig.4-1.
IMPORTANT:

1. It is recommended dealing with Clean box, to keep maintaining the dustproof environment.

 (Refer to "3.2. Clean Box" section of this service manual for details.)

2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, keep covering the lens unit with Lens caps (front

& rear), other than necessary cases.

3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
6. 5th lens has the "Nano Surface Coating".

Avoid damage the coating, please clean it with soft dry cloth. (Don’t use chemicals)

7. When tightening screws, use a Torque driver (RFKZ0456) with specified torque mentioned in each step.

10

1. Install the LENS MOUNT RUBBER

2. Install the L MOUNT UNIT

11

1. DECO.RING is stuck on the 1ST LENS FRAME UNIT. 
2. It can be easy to remove the two-sided tape with sending hot air by hair dryer.
3. Put the sheet so that the lens glass is fully covered. 
4. Insert the small flat blade screwdriver to Gap (between the decoration ring and lens glass), and peel off the DECO.RING gen-

tly. 

1. Please insert the pins (four places) of the DECO.RING to the hole of the hood adapter.

• Use new one, do not use the one which is removed.
• Double-stick tape sticks to the DECO.RING of the repair part. Please remove the old double-stick tape from HOOD

ADAPTER.

2. After installing the DECO.RING, use a soft cloth to press it into place. 

12

1. Blow off the dust first, then sweep out the dust from narrower spaces with soft cleaning brush.
2. Wipe up the Outer casing part with the dry fuzz-free cloth.

Define the location of the dust / dirt first, whether it is outside lens surface or not.

1. When it is outside surface of the lens

When the dust and / or dirt gets on the outer side surface of the Lens glasses, order the following procedures.

a. Blow off the dust on the Lens glass surface with the Blower, gently. (Do not Blow too strongly.)
b. Wipe out the dirt on the lens glass surface with Lens cleaning KIT (VFK1900BK) if necessary.

(Consult the Instruction sheet which is included in the Lens cleaning KIT in details.)
NOTE :
5th lens has the "Nano Surface Coating".
Avoid damage the coating, please clean it with soft dry cloth. (Don't use chemicals)

2. When it is inside of the lens

When there is dust / dirt inside surface of the 1st / 5th lens frame unit, remove it by referring to the following procedures. 

1. When removing the 1st / 5th lens frame unit, it has to be proceed inside of satisfied clean level. 

(Less than class 10,000 (Federal Standard 209D)) 
As for clean box, refer to the "3.2. Clean Box", in details. 

2. When install the screws, use torque driver (RFKZ0456) with specified torque. 
3. To keep the Lens performance, can only use the original 1st/5th lens frame unit . 

So the 1st / 5th lens frame unit is not supplied as spare parts. 
Also do not exchange the 1st / 5th lens  frame unit taking from others.

4. 5th lens has the "Nano Surface Coating".

Avoid damage the coating, please clean it with soft dry cloth. (Don't use chemicals)