Panasonic H-H020PP / H-H020E / H-H020GK Service Manual ▷ View online
13
5.2.1.
Disassembly procedure
Important:
It must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000 (Federal
Standard 209D))
(Satisfied clean level: Less than class 10,000 (Federal
Standard 209D))
5.2.1.1.
Removal of the Decoration Ring
1. Decoration ring is sticked on the 1st lens frame unit.
2. Put the sheet so that the lens glass is fully covered.
3. Insert the needle to Gap (A) (between the decoration ring
2. Put the sheet so that the lens glass is fully covered.
3. Insert the needle to Gap (A) (between the decoration ring
and lens glass), and peel off the decoration ring gently.
5.2.1.2.
Removal of the 1st Lens Frame
Unit
Unit
1. Remove the 3 screws (A).
2. Blow off the dust on the surface of the lens with a blower
brush.
3. Use lens cleaning KIT(BK) (VFK1900BK), if necessary.
5.2.1.3.
Removal of a dust /dirt
1. Blow off the dust on the surface of the lens with a blower
brush.
2. Use lens cleaning KIT(BK) (VFK1900BK), if necessary.
14
5.2.2.
Assembly procedure
Important:
When tightening the screw, use a torque driver (RFKZ0456)
by ordering the screwing order with specified torque
described in each step.
by ordering the screwing order with specified torque
described in each step.
5.2.2.1.
Installation of the 1st lens frame
unit
unit
1. Tighten the 3 screws (A) with specified torque in numeri-
cal order.
(Torque Driver: RFKZ0456)
(Torque: 8 ± 1.0 N-cm)
(Torque Driver: RFKZ0456)
(Torque: 8 ± 1.0 N-cm)
5.2.2.2.
Installation of the Decoration Ring
1. Install the decoration ring by referring the phase mark.
(Use new one, do not use the one which is removed.)
2. After installing the decoration ring, press the decoration
ring with finger.
15
6 EXPLODED VIEWS
6.1.
Frame & Casing Section
16
6.2.
PACKING PARTS & ACCESSORIES SECTION
Click on the first or last page to see other H-H020PP / H-H020E / H-H020GK service manuals if exist.