DOWNLOAD Panasonic H-F008PP / H-F008E / H-F008GK Service Manual ↓ Size: 1.56 MB | Pages: 14 in PDF or view online for FREE

9

It is recommended dealing with Clean box, to keep maintaining the dustproof environment.
(Refer to “3.2. Clean Box” section of this service manual for details.)
    
IMPORTANT:

1. When servicing the surrounding part with red line (refer to Fig.D1), it must be performed inside of

satisfied clean level. (Satisfied clean level: Less than class 10,000 Federal Standard 209D).
As for procedure, refer to the “5 Maintenance” for details.

2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, 

keep covering the lens unit with Lens caps (front & rear), other than necessary cases.

3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).

     
Proceed disassemble/ and assemble, by referring the following table and Fig.D1
NOTE:

1. When tightening the screw, use a Torque driver (RFKZ0456) by ordering the screwing order with specified 

torque mentioned in each step.

2. Use VFK1390 (small driver) when removing/tighten the B13.
3. The Ref.B12 is no need to remove / install for disassembly and assembly.

If necessary, use VFK1390 (small driver) when screwing

Fig. D1

10

Before starting the following disassembling, remove the concerned parts by referring the “4.1.Disassembly/Assembly procedures”.

1. It must be performed inside of satisfied clean level.

(Satisfied clean level: Less than class 10,000 Federal Standard 209D).

         
1.Removal of the Lens ring 2 U.
NOTE:

Before starting the following disassembling, remove the 
concerned parts by referring the "4.1.Disassembly/Assem-
bly procedures".
    
*.Remove 3 screws (A).

Do not remove 3 screws (A) by facing “the lens hood to the
work desk” condition.
Otherwise, the Lens main block unit is dropped/damaged.

*.Remove 6 screws (B).

11

*.Install  6 screws (B) by ordering the following
screwing trque and numerical screwing order.
[Torque] : 10±1.2 N-cm
[Screwing order] : numerical order.(“(1)” to “(6)”)

*.Install the Dust proof ring F and the Lens ring 2U.
*.Install  3 screws (A) by ordering the following
screwing trque and numerical screwing order.
[Torque] : 20±3 N-cm
[Screwing order] : numerical order.(“(1)” to “(3)”)

Install the concerned parts by referring the “4.1.Disassem-
bly/Assembly procedures”.
When screwing the screws, follow the screwing torque and
screwing order.

12