DOWNLOAD Panasonic WV-CS950 / WV-CS954E Service Manual ↓ Size: 6.22 MB | Pages: 69 in PDF or view online for FREE

ORDER NO. AVS0504621C8

WV-CS950, WV-CS954E

M a t s u s h i t a   E l e c t r i c   I n d u s t r i a l   C o . ,   L t d .

A l l   r i g h t s   r e s e r v e d .   U n a u t h o r i z e d   c o p y i n g   a n d
d i s t r i b u t i o n   i s   a   v i o l a t i o n   o f   l a w .

2 0 0 5

WV-CS954E

WV-CS950

Power Requirements

24 V AC, 50 Hz

220 V - 240 V AC, 50 Hz

Power Consumption

13 W

Pick-up Device

1/4-type {1/4"} interline transfer CCD

Effective Pixels

752 (H) x 582 (V)

Scanning Area

3.65 mm (H) x 2.71 mm (V)

Signal

PAL

Synchronization

Internal (INT), multiplexed vertical drive (VD2), link-lock (LL)

Scanning

2:1 interlace

Scanning Frequencies

Horizontal: 15.625 kHz, Vertical: 50.00 Hz

Video Output

VBS: 1.0 V [P-P]/75 

Ω

(BNC plug)

Resolution (Centre)

Horizontal : 480 lines minimum (colour NORMAL mode)

540 lines typ. , 520 lines minimum (colour HIGH mode)

570 lines minimum (black and white) 

Vertical

: 400 lines minimum (Centre)

Minimum Illumination

0.5 lux (colour mode)

0.04 lux (black and white mode) 

SENS UP: OFF; AGC: HIGH 

Dynamic Range

54 dB typ. (SUPER-D

3: ON) 

S/N Ratio

50 dB minimum (AGC: OFF) 

Ambient Operating Temperature

-10 

°

C to 50 

°

C; Humidity 90 % max. (non-condensation)

Dimensions

154.5 mm (D) x 233 mm (H) 

Weight

Approximately 2.2 kg

Finish

Camera: Die cast aluminum with baked melanin coating (Paint color: Fine silver)

Dome: Clear acrylic resin 

●

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DO NOT REMOVE COVER (OR BACK). NO USER 
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.

This symbol warns the user that uninsulated voltage within 
the unit may have sufficient magnitude to cause electric 
shock. Therefore, it is dangerous to make any kind of contact 
with any inside part of this unit.

This symbol alerts the user that important literature concerning 
the operation and maintenance of this has been included.
Therefore,  it  should  be  read  carefully  in  order  to avoid 
any problems.

T

here are special components used in this equipment which are important for safety. These parts are indicated 

by the ”

 

Y

 

” mark on the schematic diagram and the replacement parts list. It is essential that these critical 

parts should be replaced with manufacturer's specified parts to prevent X-radiation, shock, fire, or other hazards.

Do not modify the original design without permission of manufacture.

PCBs (manufactured) using lead free solder (PbF) will have a stamp on the PCB.

8

Lead free solder has a higher melting point than standard solder. Typically the melting points is 35 

°

C – 40 

°

C

(95 

°

F – 104 

°

F) higher. Please use a soldering iron with temperature control and adjust it to 360 

°

C – 370 

°

C

(680 

°

F – 698 

°

F). In case of using high temperature soldering iron, please be careful not to heat too long.

8

Lead free solder will tend to splash when heated too high (600 

°

C / 1112 

°

F).

8

Lead free solder (Sn - 3.0Ag – 0.5Cu) or equivalents are recommended on repairing our lead free soldered PCB.

Y

   WARNING

This service information is designed for experienced repair technicians only and is not designed for use by the 
general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to 
service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any 
attempt to service or repair the product or products dealt with in this service information by anyone else could 
result in serious injury or death.

Panning Range

360

°

endless

Panning Modes

Manual, auto, manual position, sequential position 

Panning Speed*

Manual: Approximately 0.065 

°

/s to 120 

°

/s  8 steps, 16 steps, 64 steps

Preset: Approximately 400 

°

/s

Tilting Range

-5

°

to 185

°

(horizontal - vertical - horizontal)

(According to the TILT ANGLE)

Tilting Modes

Manual, manual position, sequential position 

Tilting Speed*

Manual: Approximately 0.065 

°

/s to 120 

°

/s  8 steps, 16 steps, 64 steps 

Preset: Approximately 400 

°

/s

* Actual speed depends on type of controller being used. 

●

Operating Instructions....................................................1 pc.
Decorative Cover ...........................................................1 pc.
Dust Protection Sheet.....................................................1 pc.
8P Alarm Cable ..............................................................1 pc.
4P Alarm Cable ..............................................................1 pc.
Connector for 24 V  AC (only for WV-CS954E) ..............1 pc.

Zoom Ratio

30x (Approximately 300x with digital zoom) 

Focal Length

3.8 mm to 114 mm

Maximum Aperture Ratio

1:1.4 (WIDE) to 3.7 (TELE) 

Object Distance

1.5 m

Iris Range

F1.4 to 22, Close

Angular Field of View

Horizontal: 1.9

°

(TELE) to 52

°

(WIDE)

Vertical: 1.4

°

(TELE) to 40

°

(WIDE)

Controller Interface

Coaxial Multiplex System, RS485

Control Functions

Pan and tilt, zoom and focus, 256 preset positions, home position, patrol

AGC

ON (LOW), ON (MID), ON (HIGH), OFF

Title (ID)

ON, OFF (Preset ID, camera ID, area title: 16 alphanumeric characters) 

Zoom Speed

Approximately 6.0 seconds (TELE to WIDE) in manual mode 

Zoom Limit

1x to 300x (Over 30x is electronic zoom)

Password Lock

All menus 

Auto Focus

MANUAL/AUTO (PAN, TILT, ZOOM linked) 

Iris

ALC (Adjustable OPEN/CLOSE output target level)/MANUAL

Shutter

OFF (1/50), AUTO, 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000

Electronic Sensitivity Enhancement

32X max. (AUTO or FIX)

Auto Mode

OFF, SEQ, SORT, AUTO PAN, PATROL, AUTO TRACK

Auto Pan Key

SEQ, SORT, AUTO PAN, PATROL, AUTO TRACK

Digital Flip

ON/OFF

SUPER-D

3

ON/OFF

Motion Detector

OFF/MODE1/MODE2

Alarm Input/Output

4 inputs (ALARM IN 1 to ALARM IN 4)

2 outputs (ALARM/AUX1, BW/AUX2)

Black and White Mode Switching

AUTO/ON/OFF

Privacy Zone

ON/OFF (8 zone settings) 

Patrol

STOP/PLAY/LEARN 

Cleaning

ON/OFF

Image Hold

ON/OFF

Auto Image Stabilizer

ON/OFF

Scene Select Setting

INDOOR (L) /INDOOR (H) /OUTDOOR (L) /OUTDOOR (H)

Language Setting

Japanese, English, German, French, Italian, Spanish, Russian, Chinese 

●

●

THIS PUBLICATION IS PROVIDED “AS IS” WITHOUT
WARRANTY OF ANY KIND, EITHER EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO, THE
IMPLIED WARRANTIES OF MERCHANTABILITY, FIT-
NESS FOR ANY PARTICULAR PURPOSE, OR NON-
INFRINGEMENT OF THE THIRD PARTY'S RIGHT.

THIS PUBLICATION COULD INCLUDE TECHNICAL
INACCURACIES OR TYPOGRAPHICAL ERRORS.
CHANGES ARE ADDED TO THE INFORMATION
HEREIN, AT ANY TIME, FOR THE IMPROVEMENTS OF
THIS PUBLICATION AND/OR THE CORRESPONDING
PRODUCT(S).

IN NO EVENT SHALL MATSUSHITA ELECTRIC
INDUSTRIAL CO., LTD. BE LIABLE TO ANY PARTY OR
ANY PERSON, EXCEPT FOR REPLACEMENT OR
REASONABLE MAINTENANCE OF THE PRODUCT,
FOR THE CASES, INCLUDING BUT NOT LIMITED TO
BELOW:

(1) ANY DAMAGE AND LOSS, INCLUDING WITH-

OUT LIMITATION, DIRECT OR INDIRECT, SPE-
CIAL, CONSEQUENTIAL OR EXEMPLARY,
ARISING OUT OF OR RELATING TO THE
PRODUCT;

(2) PERSONAL INJURY OR ANY DAMAGE

CAUSED BY INAPPROPRIATE USE OR NEGLI-
GENT OPERATION OF THE USER;

(3) UNAUTHORIZED DISASSEMBLE, REPAIR OR

MODIFICATION OF THE PRODUCT BY THE
USER;

(4) INCONVENIENCE OR ANY LOSS ARISING

WHEN IMAGES ARE NOT DISPLAYED, DUE TO
ANY REASON OR CAUSE INCLUDING ANY
FAILURE OR PROBLEM OF THE PRODUCT;

(5) ANY PROBLEM, CONSEQUENTIAL INCONVE-

NIENCE, OR LOSS OR DAMAGE, ARISING OUT
OF THE SYSTEM COMBINED BY THE DEVICES
OF THIRD PARTY.

(6) ANY CLAIM OR ACTION FOR DAMAGES,

BROUGHT BY ANY PERSON OR ORGANIZA-
TION BEING PHOTOGENIC SUBJECT, DUE TO
VIOLATION OF PRIVACY WITH THE RESULT OF
THAT SURVEILLANCE-CAMERA's PICTURE,
INCLUDING SAVED DATA, FOR SOME REA-
SON, BECOMES PUBLIC OR IS USED FOR THE
PURPOSE OTHER THAN SURVEILLANCE.

(7) ANY PROBLEM, CONSEQUENTIAL INCONVE-

NIENCE, ANY LOSS OR DAMAGE, ARISING
OUT OF THE IMPROPER DETECTION OR SLIP-
UP IN DETECTION BY VMD (Video Motion
Detector) FUNCTION OF THE PRODUCT.