Panasonic BB-HCM701CE Service Manual ▷ View online
21
BB-HCM701CE
6.1.3.
Connecting External Sensors
22
BB-HCM701CE
6.2.
Setup
Abbreviations
• UPnP is the abbreviation for “Universal Plug and Play”.
• The Network Camera is referred to as “the camera” in this section.
• The Setup CD-ROM is referred to as “the CD-ROM” in this section.
• The Network Camera is referred to as “the camera” in this section.
• The Setup CD-ROM is referred to as “the CD-ROM” in this section.
23
BB-HCM701CE
24
BB-HCM701CE
6.3.
Mounting the Camera
6.3.1.
Important Information Regarding Camera Mounting
Please read the following information before mounting the camera. Consult an authorised dealer for mounting.
Caution:
Caution:
• Make sure you attach the safety wire when mounting the camera on a ceiling to prevent the camera from falling.
Note:
• The camera is intended for indoor use only and should not be mounted outdoors.
• The included screws are for use with wooden ceilings only.
• Use screws that are appropriate for the material of ceiling.
• If the ceiling or wall material is mortar or concrete, see P.26 “When mounting the camera on a concrete or mortar ceiling”.
• Do not drive the screws into a soft material. Drive the screws into a secure, 25 mm (1 inch) thick area of the ceiling or wall, such
• The included screws are for use with wooden ceilings only.
• Use screws that are appropriate for the material of ceiling.
• If the ceiling or wall material is mortar or concrete, see P.26 “When mounting the camera on a concrete or mortar ceiling”.
• Do not drive the screws into a soft material. Drive the screws into a secure, 25 mm (1 inch) thick area of the ceiling or wall, such
as a crossbeam, otherwise the camera may fall. If there is no crossbeam, place a board on the other side of the ceiling or wall to
make sure the camera is securely mounted.
make sure the camera is securely mounted.
• The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
• Mount the camera to a flat horizontal ceiling surface or vertical wall. (The camera cannot be used on surfaces that have more
• Mount the camera to a flat horizontal ceiling surface or vertical wall. (The camera cannot be used on surfaces that have more
than a 15
° slant.)
• The camera cover must be removed in order to insert or remove the SD memory card.
• The camera’s MAC address and serial number are printed on the bottom of the camera and are needed in order for camera con-
• The camera’s MAC address and serial number are printed on the bottom of the camera and are needed in order for camera con-
figuration and maintenance. Make a note of both of them before mounting the camera.
• Mounting and cabling instructions described in this document follow generally accepted guidelines suitable for residential instal-
lations. In some areas, commercial and industrial installations are regulated by local or state ordinances. For such installations,
contact your local building department or building inspector for more details.
contact your local building department or building inspector for more details.
• Camera images can be viewed in relatively dark areas, however, image quality decreases when viewing dark images. We rec-
ommend using supplemental lighting for best results.
• Prolonged exposure to direct sunlight or halogen light may damage the camera’s image sensor. Mount the camera appropriately.
• Do not directly touch the lens cover. Clean the lens cover with a dry and soft cloth if necessary.
• When mounting the camera, make sure to wrap the AC adaptor cord (if used) around the hooks as shown to ensure secure con-
• Do not directly touch the lens cover. Clean the lens cover with a dry and soft cloth if necessary.
• When mounting the camera, make sure to wrap the AC adaptor cord (if used) around the hooks as shown to ensure secure con-
nections.
• Adjust the installation location and the direction the camera is facing while watching the actual camera image being displayed on
a computer screen.
Click on the first or last page to see other BB-HCM701CE service manuals if exist.