Panasonic CQ-VX100W Service Manual ▷ View online
9
IC608 : C0JBAB000255
IC701 : C0DAZHF00004
IC702 : C0DBAZC00010
IC704 : C0EBY0000389
IC706 : C0DBCFG00011
IC710 : C0CBCYG00004
4.2.2.
TFT Block
IC401 : C0DBAYY00269
10
IC402 : AP2202KADJTR
IC451 : C0DBAYY00279
IC452 : C0FBBY000047
IC901 : C0ABBB000069
IC802 : C3EBCY000018
IC906 : C0BBAA000039
11
5 Disassembly and Assembly Instructions
5.1.
How to Remove the Flexible PCB
Front Panel
Front Panel
FFC
Connector
Cover
Cover
Plate
4. Disconnect the FPC Ass'y from CN452 on the TFT
PCB
.
CN452
FPC Ass'y
CN707
Front Panel
Slide Mechanism
Ass'y
Ass'y
(Monitor Ass'y)
Monitor
Disassembly of Display Unit
. Remove the two screws( ) from the Front Panel.
2. After removing the screw ( ) from the bottom side, remove
the Connector Cover.
the Connector Cover.
3. Disconnect the FFC, which is connected to
the Front Panel, from CN707 on the Main PCB.
the Front Panel, from CN707 on the Main PCB.
1. Pull out the Monitor to the arrow direction.
2. After removing the two screws ( ) and one screw ( ),
remove the Plate.
remove the Plate.
3. After removing the four screws ( ), remove the Monitor Ass'y.
4.Remove the Front Panel.
Front Panel
Monitor
12
5.2.
How to Disassemble & assemble
First take off the monitor block
and must be as shown above.
and must be as shown above.
Remove the screws from the 3
spots as shown above labled with
circles.
spots as shown above labled with
circles.
Take off the metal that fixes the
connecter and remove the screws
from the 2 spots labled with circles.
connecter and remove the screws
from the 2 spots labled with circles.
Remove the screws from the
2spots labled with circles.
2spots labled with circles.
Must be situated as shown above
then remove the locks on the flat
cable of the deck.
then remove the locks on the flat
cable of the deck.
Remove the deck block and it is
done.
done.
How to assemble
How to disassemble
Insert the flat cable.
(Caution for inserting diagonally)
(Caution for inserting diagonally)
With pad on the rear side of the deck ass’
y, there must be no gap between the deck
ass’y and the tuner shield case.
y, there must be no gap between the deck
ass’y and the tuner shield case.
Match the connector bracket with the slit of the RCA cord ass’y
and fasten them with 3 screws.
Do not let the ANT receptacle wires get jammed.
and fasten them with 3 screws.
Do not let the ANT receptacle wires get jammed.
Importan
Importan
Match the mounting spots of the deck ass’y and fasten
them with 2 screws.
The deck ass’y must be inside the front plate of the under
cover.
them with 2 screws.
The deck ass’y must be inside the front plate of the under
cover.
Fasten the 2 parts labeled with a
circle with screws.
circle with screws.
Click on the first or last page to see other CQ-VX100W service manuals if exist.