Panasonic CQ-C5302W Service Manual ▷ View online
General
Power Supply
DC 12V (11V - 16V),
Test Voltage 14.4V
Negative Ground
Current Consumption
Less than 2.2A (CD mode ; 0.5W
4-channels)
4-channels)
Maximum Power Output
50W×4 (at 1kHz)
Tone/SQ Adjustment Range
SQ Low/Bass ; ±12dB
(at 60Hz, 80Hz, 100Hz, 200Hz)
(at 60Hz, 80Hz, 100Hz, 200Hz)
SQ Mid ; ±12dB
(at 500Hz, 1kHz, 2kHz, 3kHz)
(at 500Hz, 1kHz, 2kHz, 3kHz)
SQ High/Treble ; ±12dB
(at 10kHz, 12kHz, 15kHz, 18kHz)
(at 10kHz, 12kHz, 15kHz, 18kHz)
Speaker Impedance
4-8
Ω
Pre-Amp Output Voltage
2.5V (CD mode; 1kHz, 0dB)
Pre-Amp Output Impedance
200
Ω
Subwoofer Output Voltage
2.5V
Subwoofer Output Impedance
200
Ω
FM Stereo Radio
Frequency Range
87.5MHz - 108.0MHz
Usable Sensitivity
6dB/µV. (S/N 30dB)
Frequency Response
30Hz-15kHz (±3dB)
Alternate Channel Selectivity
75dB
Stereo Separation
35dB (1kHz)
Image Rejection Ratio
70dB
IF Rejection Ratio
100dB
CQ-C5302W
WMA MP3 CD Player/Receiver with CD
Changer Control
Changer Control
Signal to Noise Ratio
62dB
AM Radio
Frequency Range
531kHz - 1,602kHz
Usable Sensitivity
28dB/µV (S/N 20dB)
CD Player
Sampling Frequency
8 Times Oversampling
DA Converter
1bit DAC System
Pick-Up Type
Astigma 3-beam
Light Source
Semiconductor Laser
Wave Length
790nm
Frequency Response
20Hz to 20kHz (±1dB)
Signal to Noise Ratio
96dB
Total Harmonic Distortion
0.01% (1kHz)
Wow and Flutter
Below measurable limits
Channel Separation
75dB
Dimensions** (W×H×D)
178×50×155mm
Weight**
1.6kg
* Specifications and the design are subject to possible modification
without notice due to improvements.
without notice due to improvements.
** Dimensions and Weight shown are approximate.
•
•
•
•
Above specifications comply with EIA standards.
AUTOMOTIVE AFTERMARKET
Specifications*
ORDER NO. ACED060610C3
1 ABOUT LEAD FREE SOLDER (PbF)
3
2 LASER PRODUCTS
3
3 FEATUERS
3
4 REPLACING THE FUSE
3
5 MAINTENANCE
3
6 NOTES
3
7 DIMENSIONS
3
8 WIRING CONNECTION
4
9 DISASSEMBLY INSTRUCTIONS
5
10 TERMINALS DESCRIPTION
8
11 PACKAGE AND IC BLOCK DIAGRAM
11
12 REPLACEMENT PARTS LIST
14
13 EXPLODED VIEW (Unit)
19
14 CD PLAYER PARTS LIST
20
15 EXPLODED VIEW (CD Deck)
23
16 WIRING DIAGRAM
24
17 SCHEMATIC DIAGRAM
29
18 BLOCK DIAGRAM
33
CONTENTS
Page
Page
2
CQ-C5302W
1 ABOUT LEAD FREE
SOLDER (PbF)
Distinction of PbF PCB:
PCBs (manufactured) using lead free solder will have a PbF
stamp on the PCB.
Caution :
PCBs (manufactured) using lead free solder will have a PbF
stamp on the PCB.
Caution :
•
•
•
•
Pb free solder has a higher melting point than standard
solder; Typically the melting point is 50 - 70°F (30 -
40°C) higher. Please use a soldering iron with
temperature control and adjust it to 700 ± 20°F (370 ±
10°C). In case of using high temperature soldering iron,
please be careful not to heat too long.
solder; Typically the melting point is 50 - 70°F (30 -
40°C) higher. Please use a soldering iron with
temperature control and adjust it to 700 ± 20°F (370 ±
10°C). In case of using high temperature soldering iron,
please be careful not to heat too long.
•
•
•
•
Pb free solder will tend to splash when heated too high
(about 1100°F/600°C)
(about 1100°F/600°C)
•
•
•
•
This lead free solder will be used for the products after
serial No. 1,000,001.
serial No. 1,000,001.
2 LASER PRODUCTS
3 FEATUERS
•
•
•
•
Digital servo for reliable playback.
•
•
•
•
PLL (Phase Locked Loop) synthesized tuning.
•
•
•
•
18-FM, 6-AM presets with preset scan.
•
•
•
•
Removable face plate.
•
•
•
•
MP3/WMA Playback from CD-R/RW.
•
•
•
•
CD Changer Control.
4 REPLACING THE FUSE
Use fuses of the same specified rating (15amps). Using
different substitutes or fuses with higher ratings, or connecting
the product directly without a fuse, could cause fire or damage
to the stereo unit.
different substitutes or fuses with higher ratings, or connecting
the product directly without a fuse, could cause fire or damage
to the stereo unit.
5 MAINTENANCE
Your product is designed and manufactured to ensure a
minimum of maintenance. Use a dry, a soft cloth for routine
exterior cleaning. Never use benzine, thinner or other solvents.
minimum of maintenance. Use a dry, a soft cloth for routine
exterior cleaning. Never use benzine, thinner or other solvents.
6 NOTES
[RADIO BLOCK]
Do not align the AM/FM package block. When the package
block is necessary, it will be supplied already aligned at the
factory.
[CD DECK BLOCK]
This model has no servo alignment points because
microcomputer controls the servo circuit.
Do not align the AM/FM package block. When the package
block is necessary, it will be supplied already aligned at the
factory.
[CD DECK BLOCK]
This model has no servo alignment points because
microcomputer controls the servo circuit.
7 DIMENSIONS
3
CQ-C5302W
8 WIRING CONNECTION
4
CQ-C5302W
