Panasonic SC-HC17EB / SC-HC17EC / SC-HC17EE / SC-HC17EG Service Manual ▷ View online
45
Step 4 : Lift up the Guide.
Step 5 : Push the tip of the Door Shaft inwards as arrow shown.
Step 5 : Push the tip of the Door Shaft inwards as arrow shown.
Step 6 : Upset the Front Cabinet Assembly.
Step 7 : Remove the Door Shaft.
Step 8 : Remove the Slider Bottom.
Step 7 : Remove the Door Shaft.
Step 8 : Remove the Slider Bottom.
46
10.12.2. Assembly of Bridge P.C.B., Door
Shaft & Slider Bottom
Step 1 : Insert the Slider Bottom into the Door Shaft.
Caution : During assembling, ensure the Slider Bottom is
turned downwards as diagram show.
turned downwards as diagram show.
Step 2 : Insert one end of the Door Shaft into the hole as dia-
gram shown.
gram shown.
Step 3 : Push the Door Shaft downwards and insert into the
hole.
hole.
47
Step 4 : Upset the Front Cabinet Assembly.
Step 5 : Push the Door Shaft as arrow shown.
Step 6 : Make sure that the Door Shaft is fixed by the Guide.
Step 5 : Push the Door Shaft as arrow shown.
Step 6 : Make sure that the Door Shaft is fixed by the Guide.
Step 7 : Apply Neijilock.
Step 8 : Place back the Bridge P.C.B..
Caution : During assembling, ensure the Bridge P.C.B. is
properly seated onto the 2 locators.
properly seated onto the 2 locators.
Step 9 : Fix 2 screws.
48
10.13. Disassembly of Position
Switch P.C.B. & Timing Gear
Unit
Unit
• Refer to “Disassembly of Net Frame Assembly (L) & (R)”
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of CD Door Ornament”
• Refer to “Disassembly of CD Door Base”
• Refer to “Disassembly of Front Cabinet Assembly”
• Refer to “Disassembly of Gear Box Assembly”
• Refer to (Step 1) - (Step 3) of item 10.11.1.
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of CD Door Ornament”
• Refer to “Disassembly of CD Door Base”
• Refer to “Disassembly of Front Cabinet Assembly”
• Refer to “Disassembly of Gear Box Assembly”
• Refer to (Step 1) - (Step 3) of item 10.11.1.
Step 1 : Remove 1 screw.
Step 2 : Release the 5P Wire & 2P Wire from the slots.
Step 3 : Remove the Position Switch P.C.B..
Caution : During assembling, ensure the Position Switch
P.C.B. is fully catched and properly seated on the locator.
P.C.B. is fully catched and properly seated on the locator.
Click on the first or last page to see other SC-HC17EB / SC-HC17EC / SC-HC17EE / SC-HC17EG service manuals if exist.