Panasonic SB-MAX700PH / SB-MAX700GS (serv.man2) Service Manual ▷ View online
13
Step 3 : Slightly lift up Front Ornament Assembly.
Step 4 : Release the 4P wire from the hole of Lower Front
Panel Assembly.
Caution : During assembling, inserted the 4P wire into the
opening of Lower Front Panel Assembly as diagram
shown.
Step 4 : Release the 4P wire from the hole of Lower Front
Panel Assembly.
Caution : During assembling, inserted the 4P wire into the
opening of Lower Front Panel Assembly as diagram
shown.
Step 5 : Remove 4 screws.
Step 6 : Release the 4P wire from the slots.
Caution : During assembling, ensure that the 4P wire is
properly inserted into the slot.
Step 6 : Release the 4P wire from the slots.
Caution : During assembling, ensure that the 4P wire is
properly inserted into the slot.
Step 7 : Remove Lighting Wire P.C.B. Assembly.
14
3.8.
Replacement of Speaker Connector Housing (For SB-MAX700PHK)
3.8.1.
Disassembly of Speaker Connector Housing
Step 1: Insert a paper clip & push the Wire terminals outwards.
Step 2: Detach the (+) and (-) speaker wire.
Step 2: Detach the (+) and (-) speaker wire.
3.8.2.
Assembly of Speaker Connector
Housing
Housing
Step 1: Slightly lift up the wire terminals approximately 45
° as
shown.
Step 2: Insert the (+) speaker wire into the (+) hole of the
Speaker Connector Housing.
Step 3: Push in the speaker wire until hear the “click” sound.
Speaker Connector Housing.
Step 3: Push in the speaker wire until hear the “click” sound.
Step 4: Insert the (-) speaker wire into the (-) hole of the
speaker connector housing.
Step 5: Push in the speaker wire until hear the “click” sound.
speaker connector housing.
Step 5: Push in the speaker wire until hear the “click” sound.
Step 6: Pull both speaker wires gently to ensure they lock-in
firmly.
Note: Repeat these procedures if the speaker wires come out.
firmly.
Note: Repeat these procedures if the speaker wires come out.
15
3.9.
Replacement of Speaker Connector Housing (For SB-MAX700PHK)
For Speaker wire connection, please refer to 1.2. Speaker setup
3.9.1.
Disassembly of Speaker Connector Housing
Step 1: Insert a paper clip & push the Wire terminals outwards.
Step 2: Detach the (+) and (-) speaker wire.
Step 2: Detach the (+) and (-) speaker wire.
3.9.2.
Assembly Disassembly of Speaker
Connector Housing
Connector Housing
Step 1: Slightly lift up the wire terminals approximately 45
° as
shown.
Step 2: Insert the (+) speaker wire into the (+) hole of the
Speaker Connector Housing.
Step 3: Push in the speaker wire until hear the “click” sound.
Speaker Connector Housing.
Step 3: Push in the speaker wire until hear the “click” sound.
Step 4: Insert the (-) speaker wire into the (-) hole of the
speaker connector housing.
Step 5: Push in the speaker wire until hear the “click” sound.
speaker connector housing.
Step 5: Push in the speaker wire until hear the “click” sound.
Step 6: Pull both speaker wires gently to ensure they lock-in
firmly.
Note: Repeat these procedures if the speaker wires come out.
firmly.
Note: Repeat these procedures if the speaker wires come out.
16
4 Wiring Connection Diagram
4.1.
Front Speakers (SB-MAX700PHK)
Click on the first or last page to see other SB-MAX700PH / SB-MAX700GS (serv.man2) service manuals if exist.