Panasonic SA-PM38EG / SA-PM38EF / SA-PM38EB / SA-PM38EP / SC-PM38EP Service Manual ▷ View online
45
11.2. Assembling Procedure
Caution : Removal of the short pin is necessary for
replacement of new traverse unit.
Step 1 : Release the guide.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
46
Step 3 : Slot the traverse unit at approximately 45° into the
mecha chassis as arrow shown.
Caution : Ensure the bosses fix exactly onto the guides.
mecha chassis as arrow shown.
Caution : Ensure the bosses fix exactly onto the guides.
Step 4 : Release the guide.
Step 5 : Push the traverse slide plate (rib) to lock the traverse
unit in.
Step 5 : Push the traverse slide plate (rib) to lock the traverse
unit in.
47
12 Service Position
Note: For description of the disassembly procedures, see the Section 10
12.1. Checking & Repairing USB
P.C.B.
Step 1 : Remove Top Cabinet Assembly.
Step 2 : Detach 11P FFC at connector (CN901) on Main
P.C.B..
P.C.B..
Step 3 : Release both guides.
Step 4 : Release 3 Catches.
Step 5 : Slighly remove Front Panel Assembly.
Step 4 : Release 3 Catches.
Step 5 : Slighly remove Front Panel Assembly.
Step 6 : Remove 2 screws.
48
Step 7 : Place a support block underneath the Top Cabinet
Assembly.
Step 8 : Connect 14P FFC at connector (CN350) on Main
P.C.B..
Step 9 : Connect 5P cable at connector (CN902) on Main
P.C.B..
Assembly.
Step 8 : Connect 14P FFC at connector (CN350) on Main
P.C.B..
Step 9 : Connect 5P cable at connector (CN902) on Main
P.C.B..
Step 10 : Connect 11P FFC at connector (CN901) on Main
P.C.B..
P.C.B..
Step 11 : Place a support block underneath the USB P.C.B..
Step 12 : Check & repair USB P.C.B. according to the diagram
shown.
Step 12 : Check & repair USB P.C.B. according to the diagram
shown.
Click on the first or last page to see other SA-PM38EG / SA-PM38EF / SA-PM38EB / SA-PM38EP / SC-PM38EP service manuals if exist.