Panasonic CW-C180EE / CW-C240EE / CW-A180EE Service Manual ▷ View online
9.3.7. Insert the Air Filter.
9.4.1. Remove the Front Intake Grille.
•
•
•
•
Raise the Front Intake Grille by approximately 90°. Slide it
to the left to unhinge then pull outwards.
to the left to unhinge then pull outwards.
9.4.2. Remove the Air Filter.
•
•
•
•
Lift the air filter by the holder and pull outwards.
9.3.8.
Attach the Front Intake Grille.
•
•
•
•
Slide the Front Intake Grille slightly to the right to attach it,
then push down to secure it.
then push down to secure it.
9.4.3. Remove the Front Grille.
1. Open the Control Panel cover.
When performing the following steps, do not pull the bottom
edge of the Front Grille towards you more than 3 inches or
you may damage the top tabs.
edge of the Front Grille towards you more than 3 inches or
you may damage the top tabs.
2. Press inward on the Cabinet near the bottom right side of
the Front Grille while pulling the Front Grille to the right then
slightly towards you to release the right tab.
slightly towards you to release the right tab.
3. Press inward on the Cabinet near the bottom left side of the
Front Grille while pulling the Front Grille to the left then
slightly towards you to release the left tab.
slightly towards you to release the left tab.
4. Slide the Front Grille upwards to release the two top tabs.
9.4. Removal of the Front Grille.
17
CW-C180EE / CW-C240EE / CW-A180EE
9.5. Condensed Water Drainage.
This air conditioner employs a “Slinger-Up System” which is
designed to splash the condensed water on the condenser coil
for maximum cooling efficiency, thus producing a splashing
sound. If the splashing sound annoys you, you can provide an
outside drainage by using the following procedure which may,
however, cause a small loss of performance.
Note: If the unit is installed at coastal area, drainage of
condensed water is recommended to prevent the condenser
being corroded easily.
1. Remove the rubber plug from the Base Pan.
designed to splash the condensed water on the condenser coil
for maximum cooling efficiency, thus producing a splashing
sound. If the splashing sound annoys you, you can provide an
outside drainage by using the following procedure which may,
however, cause a small loss of performance.
Note: If the unit is installed at coastal area, drainage of
condensed water is recommended to prevent the condenser
being corroded easily.
1. Remove the rubber plug from the Base Pan.
2. Slide out the Chassis from the Cabinet.
3. Install the Drain Pan at the right or left corner of the Cabinet
3. Install the Drain Pan at the right or left corner of the Cabinet
with 2 screws.
•
•
•
•
CW-C180EE & CW-C240EE.
•
•
•
•
CW-A180EE.
4. Connect the drain hose to the outlet of Drain Pan bottom.
5. Slide the Chassis back into the Cabinet.
Note: Drain hose or tubing can be purchased locally to satisfy
your particular needs.
5. Slide the Chassis back into the Cabinet.
Note: Drain hose or tubing can be purchased locally to satisfy
your particular needs.
18
CW-C180EE / CW-C240EE / CW-A180EE
10.1. Cleaning the Unit.
Clean the Cabinet, Front Grille with a mild soap or detergent
and lukewarm water.
and lukewarm water.
10.2. Cleaning the Front Intake
Grille.
Gently wash with water and a sponge. (Do not use a scrubbing
brush or other hard cleaning aids).
brush or other hard cleaning aids).
10.3. Cleaning the Air Filter.
1. Remove the Front Intake Grille.
2. Tilt up and pull out the Air Filter by the holder.
2. Tilt up and pull out the Air Filter by the holder.
3. Vacuum the front of the filter and then wash the back of it
with water. If it is badly soiled, wash with a mild household
detergent.
detergent.
10 Care and Maintenance
Caution: Always turn off the air conditioner and the main power supply before unplugging the power cord to clean the
unit.
Note: Do not clean with benzene, thinner, scouring powder or corrosive chemicals. Do not dry the Front Intake Grille or
the Air Filter in direct sunlight. Exposure to direct sunlight may discolor or deform the panel.
the Air Filter in direct sunlight. Exposure to direct sunlight may discolor or deform the panel.
19
CW-C180EE / CW-C240EE / CW-A180EE
1. Remove the Front Intake Grille (refer to page 16).
2. Remove the Air Filter (refer to page 16).
3. Remove the Front Grille (refer to page 16).
4. Remove the 2 knobs.
2. Remove the Air Filter (refer to page 16).
3. Remove the Front Grille (refer to page 16).
4. Remove the 2 knobs.
5. Take off the Control Panel.
6. Release the thermostat sensor from the sensor holder.
7. Loosen the 3 screws of the Control Board.
8. Slide the Control Board out from the chassis.
Control Board Part Location CW-C180EE
11 Service Information
11.1. Removal of the Control Board
20
CW-C180EE / CW-C240EE / CW-A180EE
Click on the first or last page to see other CW-C180EE / CW-C240EE / CW-A180EE service manuals if exist.