Panasonic CS-XC9CKT / CU-XC9CKT / CS-XC12CKT / CU-XC12CKT Service Manual ▷ View online
−
−
−
− Pulling out the Drain Hose from outlet to remove the
Discharge Grille. (Fig. 5)
−
−
−
− Removing the right and left screws. (Fig. 5)
−
−
−
− Then remove the Control Board by pressing down the
hook at the left and pushing up the right hook. (Fig. 5)
−
−
−
− Releasing connector lead wire Ionizer. (Fig. 5)
−
−
−
− Release the Fan Motor leadwire by pressing the hook at
the center of the connector. (Fig. 6)
−
−
−
− Remove the screw at the Cross Flow Fan. (Fig. 7)
−
−
−
− REMINDER - To reinstall the Fan Motor, adjust the
connector of the Fan Motor as shown in the Fig. 7.
Fig. 5
Fig. 6
Fig. 7
57
CS-XC9CKT CU-XC9CKT / CS-XC12CKT CU-XC12CKT
−
−
−
− Remove the screws at the left of the Evaporator. (Fig. 8)
−
−
−
− Remove the Bearing. (Fig. 9)
−
−
−
− Push up the Evaporator and pull out the Cross Flow Fan
from shaft. By then, Fan Motor can be taken out. (Fig. 9)
Fig. 8
Fig. 9
12.2. Outdoor Unit
12.2.1. Cabinet Side Plate Removal Procedures
1. The Vacuum Pump, Filter - Oxygen Generator (Fig. 4) can be seen by the below steps:
a. Remove 3 screws on the Cabinet Top Plate. (Fig. 1)
b. Pull up the Cabinet Top Plate. (Fig. 1)
Fig. 1
58
CS-XC9CKT CU-XC9CKT / CS-XC12CKT CU-XC12CKT
c. Remove 6 screws on the Cabinet Front Plate. (Fig. 2)
Fig. 2
d. Pull out the Cabinet Front Plate from your left side. (Fig. 3)
Fig. 3
e. Pull down and release the Oxygen tube from the Muffler.
(Fig. 4)
(Fig. 4)
Fig. 4
59
CS-XC9CKT CU-XC9CKT / CS-XC12CKT CU-XC12CKT
f. Remove the screw to take out the control board cover.
(Fig. 5)
(Fig. 5)
Fig. 5
g. Remove the 10 screws to take out Cabinet Side Plate right.
(Fig. 6)
(Fig. 6)
Fig. 6
Fig. 7
60
CS-XC9CKT CU-XC9CKT / CS-XC12CKT CU-XC12CKT
Click on the first or last page to see other CS-XC9CKT / CU-XC9CKT / CS-XC12CKT / CU-XC12CKT service manuals if exist.