DOWNLOAD LG WT-Y148RG Service Manual ↓ Size: 12.75 MB | Pages: 57 in PDF or view online for FREE

Model
WT-Y148RG
Pages
57
Size
12.75 MB
Type
PDF
Document
Service Manual
Brand
Device
Washing Machine
File
wt-y148rg.pdf
Date

LG WT-Y148RG Service Manual ▷ View online

8
Screw Type
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely 
to the tap.
1
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then tighten
it by screwing it to the right.
2
Check water leakage.
After connecting the hose, open the faucet to
check for any water leakage.
Connect the water supply hose to inlet valve of
the washing machine, and then lock it by
turning the hose connecting part.
Check to see if there is a rubber seal inside the
connector.
3
Connecting Water Supply Hose to the machine
 
 
Water Supply Hose
Rubber Packing
Water
tap
Hose connector
Rubber seal
9
2-3. CONNECT THE DRAIN HOSE
For pump model
2-4. FLOODING DRAINAGE
For non - pump model
NOTE
Never lay down the drain hose, as water will be discharged.
Be sure the drain hose is properly routed so it will not kink or lift  from the sink.
The discharge height should be approximately 0.9~1.2m from  the floor.
Connect the drain hose adjusting the length of it not to be dropped. If drain hose
is dropped the drainage could be poor because of blockage in the hose.
Connect the drain hose to the outlet of the  drain
located at the back side of the washing machine.
Fix the drain hose with the clip.
And then push it toward the body as in the figure.
Keep it downward while the washing machine  is working.
Ensure the hose is free from kinking.
You machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that
may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole (or
slope) that will prevent any possibility of water damage to floor coverings or property.
Do not install the washer where it is directly exposed to sunlight, wind, rain, etc.
Plug the power cord of this washer into a properly installed standard power outlet that is grounded.
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that may leak
out should the machine malfunction. It is therefore the OWNER’S RESPONSIBILITY to make sure this machine is installed in an
area with a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
Permissible water temperature : Max 70˚C (160˚F)
Permissible water pressure : Max 116psi (800 kpa, 8 kg/cm
2
), Min 4 psi (30 kpa, 0.3 kg/cm
2
)
If water temperature and pressure are greater than above, it may cause damage to the machine. If you have uncontrolled water
temperature and pressure you should fit a temperature and pressure relief valve to ensure that water temperature and water
pressure remain within the safe limits. Consult a plumber or electrician if you are unable to adjust water temperature and pressure.
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
CAUTION
Hose
Guide
Within 50mm
0.9~
1.2m
Drain Hose
Holder
Holes for the Holder
Push 
Holes
For Holder
Connect the drain hose to the
outlet of the drain pump located
at the rear of the washing
machine.
Attach the clip to the drain hose.
And then push it toward the body
of the washing  machine as
indicated by the arrow.
Check that the drain hose is hung
up over the edge of the laundry
tub.
Do not use an extension hose.
10
3-1. IDENTIFICATION OF PARTS
3. OPERATING INSTRUCTION
WATER SUPPLY
HOSE
BLEACH 
DISPENSER
FUNCTION
SELECTOR
TUB
BASE
ADJUSTABLE LEGS
DRAIN HOSE
for pump model
DRAIN HOSE
POWER PLUG
START/PAUSE
BUTTON
Use to start or 
stop the washing 
machine
temporarily.
Make sure the 
water does not 
leak.
If the supply cord is 
damaged, it must be 
replaced by the 
manufacturer or its 
service agents or 
similarly qualified 
person in order to 
avoid a hazard.
Check if the drain 
hose is hung up 
before operating the 
washing machine.
for non pump 
model
Use to level the washing
machine for correct 
balance & spin 
operation.
POWDER AND LIQUID 
DETERGENT BOX
MULTI CLEAN 
FILTER
Part can be different according to the model.
Note
Do not wash fabrics containing flammable materials 
(waxes, cleaning fluids, etc.).
Load Size
The WATER LEVEL should just cover the clothes. Adjust the load size
accordingly. Loosely load clothes no higher than the top row of holes in
the washer tub. To add items after washer has started, press START
button and submerge additional items. Close the lid and press START
button again to restart.
Light and Large-sized clothing
Clothes like downs and woollens are light weight, large and float easily.
Use a nylon net and wash them in a small amount of water. If the laundry floats during the wash cycle,
it may become damaged. Use dissolved Detergent to prevent the Detergent from clumping.
Long laundry items
Use nylon nets for long, DELICATE items. For laundry with long strings or long length , a net will
prevent tangling during washing. Fasten zippers, hook, and strings to make sure that these items
don't snag on other clothes.
Nylon net is not supplied by LG.
11
3-2. BEFORE STARTING TO WASH
Care Labels
Sorting
Pretreatment on stains or heavy soil
Check before Loading
Loading
* Look for a care label on your clothes. This will tell you about the fabric content of your garment 
and how it should be washed.
Sort clothes into loads that can be washed with the same wash cycle, Water Temperature and spin speed.
To get the best results, different fabrics need to be washed in different ways. 
• SOIL (Heavy, Normal, Light) 
Separate clothes according to the type and  amount of soil.
• COLOR (Whites, Lights, Darks)
Separate white fabrics from colored fabrics.
• LINT (Lint producers, Collectors)
Separate lint producers and lint collectors. 
Lint Producers  
Terry cloth, Chenile, Towels, Nappies, Diapers
Lint Collectors 
Synthetics, Corduroy, Permanent Press, Socks
• Check all pockets to make sure that they are empty. Things such as nails, hairclips, matches, pens, coins,
and keys can damage both your washer and your clothes. 
• Mend any torn garments or loose buttons. Tears or holes may become larger during washing. 
• Remove belts, underwires, etc. to prevent damage to the machine or your clothes.
• Pretreat any dirt and stains.
• Make sure the clothes are washable in water. 
• Check the washing instructions.
• Remove tissue in pockets.
• Pretreat shirt collars and cuffs with a pre-wash product or liquid Detergent when placing them in the washer. 
Before washing treat special stains with bar soaps, liquid Detergent or a paste of water and granular Detergent.
• Use a pretreat soil and stain remover.
Treat stains AS SOON AS POSSIBLE. The longer they are left the harder they are to remove. 
Fire Hazard
Never place items in the washer that are
dampened with gasoline or other flammable
fluids.
No washer can completely remove oil.
Do not dry anything that has ever had any type
of oil on it (including cooking oils).
Doing so can result in death, explosion, or fire.
WARNING
WIRE
Page of 57
Display

Click on the first or last page to see other WT-Y148RG service manuals if exist.