DOWNLOAD LG WT-SD173HVG Service Manual ↓ Size: 4.5 MB | Pages: 57 in PDF or view online for FREE

• Use to set a delayed finishing

time. 

• The time increases when the

button is pushed.

• The following settings are

indicated as the button is pushed
3    4    5    ...11    12    14    16
...46    48    3 HOUR.

• To cancel delay time, turn the

power switch off.
(refer to page 24)

• Use for selecting wash program.
• This button allows you to  select 8

different programs for different kinds of
laundry and soil condition.

• program selections light up in sequence

as follows: FUZZY    WOOL    QUICK
WASH    JEANS    ECO COTTON
SILENT    FAVORITE    TUB CLEAN

FUZZY etc. Select the desired

program by pressing the button.

• Use to start or pause the

washing process. 

• Repeats start and pause by

pushing the button.

• It only operates in FUZZY Program.
• During sensor detection, the LED flashes green, orange and red in turn. And, after detecting, the LED lights a

specific color according to the detecting condition as follows:  

If the current washing condition (Detergent quantity, Water Temperature, water quality, etc.) is determined
as better than the standard one, it optimizes the algorithm to save the energy by decreasing washing
time/strength, and the LED automatically turns to red.  
If the current washing condition is determined as worse than the standard one, it optimizes the algorithm by
increasing washing time/strength, and the LED automatically turns to orange.
If the current washing condition is determined as equal to the standard one, the algorithm has no change
and the LED turns to green.

• Use to turn the power on or off.
• Push again and power goes on or off 
• The power goes off automatically

about 10 seconds after the wash is
finished.

* As the detecting ability of the sensor may be decreased over time, a tub clean cycle periodically is recommended.

* Even if the water level or the water temperature are changed by the user in FUZZY Program, the sensor will still

work. The sensor algorithm may differ according to models. 

* The control panel may differ according to different models.

This program is for mixed fabrics
as normal operation. It is
automatically selects the most
appropriate wash conditions such
as wash action and cycle times by
utilizing the built-in load sensor.

• Add the appropriate

quantity of Detergent as
indicated by the
WATER LEVEL next to
WATER DETERGENT.
Or follow the Detergent
manufacturer’s
instructions

• Use neutral Detergent

appropriate for the
laundry.

• When washing woolens

use a mild Detergent
recommended for
washing wool.

• Select the

WOOL
program on
the Control
panel.

• Add the appropriate

quantity of Detergent as
indicated by the
WATER LEVEL next to
WATER DETERGENT.
Or follow the Detergent
manufacturer’s
instructions

• Select the

QUICK
WASH
program on
the Control
panel.

• Select the

JEANS
program on
the Control
panel.

• Select the 

ECO COTTON
program on the
Control panel.

• Spread

the jean
evenly in
the tub

Use this program for washing
delicate fabrics such as lingerie and
woolens. (wash only “water
washable” clothes) Before washing
your woolens check the care label
for the washing instructions. 
(wash only water washable clothes)

Use this mode when washing
lightly soiled clothes for a short
time. The highly recommended
laundry amount is under 2.0kg.

Use Jean program when washing
Jeans of different sizes

Eco Cotton is the program for
normally soiled cotton material
and designed to minimize water
consumption.

• The pulsator rotates for

8 seconds to detect the
laundry load.

• Then the WATER

LEVEL and the amount
of Detergent to be
used will be shown and
water will be supplied.

• Water will be let in

again 2 minutes
after the wash has
started to
supplement the
water the laundry
has absorbed.

• When the wash

program ends, the
chime will sound
for 10 seconds
before the Power
goes off goes off
automatically.

• If water is already in the tub, or putting

wet laundry into the tub before starting will
increase the WATER LEVEL. 

• With lightweight bulky loads, WATER

LEVEL can be set low.  

• Changes to Water Temperature

(HOT/COLD) and wash level are possible
during operation.
(refer to page 14)

• When setting the WATER LEVEL manually,

do not set below level number 6 in order to
prevent damage to the woollen clothes.

• Washing with HOT water may damage the

laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.

• In order to avoid  damage to laundry, the

spin cycle may appear slow.
This also avoids wrinkles and clothing may
still contain some water. This is normal.

• When static pressure of water is more

than 2kg/cm

2

, the QUICK WASH course

will be within 19min.

Use this mode to wash normal clothes or thick and heavy clothes which are excessively dirty. 
SOAK mode can be used with FUZZY or JEAN or ECO COTTON or SILENT or FAVORITE program.

Press the POWER (AUTO OFF) button to turn power on.

Press the PROGRAM button to select the washing program.

Press the WASH button, to select SOAK program.

Add the Detergent. 

Add the laundry and press the START/PAUSE button.

• SOAK will not work in WOOL and QUICK WASH, TUB CLEAN

Program.

• The Soak Function will only operate in Auto wash (Fuzzy logic

mode) by pressing the Wash Button until the Soak symbol
illuminates. The 3 available Soak +Wash times are 40, 50, or
60 minutes. These times include the wash time.

• The appropriate quantity of Detergent marked next to the

WATER LEVEL of WATER-DETERGENT.

• The WATER LEVEL will be shown and water will be supplied.

Close the lid. 

Finish

• Water will be let in again 2 minutes after the wash has started to

supplement the absorbed water by the laundry. 

• When the wash program ends, the chime will sound for 10

seconds before the Power goes off automatically.