DOWNLOAD LG WM-12311FD Service Manual ↓ Size: 3.81 MB | Pages: 36 in PDF or view online for FREE

(1)

Check the S.PRESSURE SWITCH
ASSEMBLY or HOSE (Pressure). 
If the problem is on the
S.PRESSURE SWITCH
ASSEMBLY or the HOSE, replace
the S.PRESSURE SWITCH
ASSEMBLY or the HOSE.

Normal

Correct the connector.

Replace the STATOR
ASSEMBLY

Check on the spinning, is the frequency of the
water level 248 or more. The frequency can be 
checked by pressing the Wash and Rinse buttons at
the same time on the program.

When pressing Rinse, Spin and POWER buttons at
the same time after power off, press the  Start/Pause
button 1 times, is the drum low speed spin?

Is it disconnected, or disassembled?
[Red:3pin(1), GY:4pin(2)]

Check the motor connector, is the resistance of

the terminal same as the figure?

Resistance of terminal: 

About 5

15

Replace the MAIN PWB ASSEMBLY

Does the spring of Latch Hook actuate?

Is there clicking sound once or twice when the
START/ PAUSE button is pressed to start the cycle?

Is DOOR SWITCH ASSEMBLY broken?

Replace Door Assembly.

Check the DOOR SWITCH
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
(Red 3 pin, Yellow 4 pin and
white 3 pin connector (1)).

Replace the DOOR
SWITCH ASSEMBLY.

9. DISASSEMBLY INSTRUCTIONS

Disassemble and repair the parts after pulling out power cord from the outlet.

①

Unscrew the screws on the top plate.

②

The  plate  assembly(Top)  is  pulled  back  and
then upward to arrow direction. 

③

The cover(Inner) is disassembled.

①

The  PWB  assembly(Display)  connectors  are
disconnected.

②

Pull out drawer, three screws are unscrewed.

③

Push  two  upper  hooks  and  pull  the  control

panel forward.

①

The PWB assembly(Display) is disconnected.

②

When  6  screws  are  unscrewed  on  the  PWB
insulator  and  the  PWB  assembly(Display)  is
disassembled from the PWB insulator.

PANEL ASSEMBLY(CONTROL)

Hook

PLATE ASSEMBLY(TOP)

PWB ASSEMBLY(DISPLAY)

①

The back cover is removed.

②

Two screws are unscrewed.

③

Disconnect connector from the wiring.

④

Pull the PWB assembly (Main) to arrow

direction.

①

The plate assembly(Top)and the

cover(lnner)are disassembled.

②

Pull the drawer to arrow direction.

③

Two screws are unscrewed.

①

The hose clamps and the hose are

disassembled. 

②

The ventilation bellows are disassembled on

the tub.

DRAWER

Option

Dispenser assembly

①

Disconnect the wiring connector.

②

Remove  the  valve  by  two  screws  of  the  valve

holder.

When reconnecting the connector

1

2

3 Option

VALVE 

(PRE-WASH)

GY/WH - BK

VALVE 

(NORMAL-WASH)

WH/BK - BK

VALVE 

®È

(NORMAL-WASH)

BL/RD - BK

VALVE 

(HOT)

BL/RD - BK

①

Open the door completely.

②

Remove the two screws from the hinge.

※

When removing the Door Assembly, it is

necessary to hold the Bracket that is inner of
the Cabinet Cover.

Pull it out from hose.

※

First, prepare a bucket to put in the remained

water.

 CAP 

(REMAINING HOSE)