LG WM-1175FHB Service Manual ▷ View online
3. PARTS IDENTIFICATION
6
Hot/Cold (2EA)
Cold (1EA)
Wrench
Power plug
Control panel
Door
Lower cover
Adjustable feet
(For detergent and
fabric softener)
Drawer
Drum
Drain hose
Lower cover cap
Drain pump filter
Drain plug
If the supply cord is damaged,
it must be replaced by the
it must be replaced by the
manufacturer or its service
agents or a similarly qualified
person in order to avoid a
hazard.
agents or a similarly qualified
person in order to avoid a
hazard.
ACCESSORIES
Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.
STANDARD INSTALLATION
The appliance should be installed as follows.
Remove the transit bolts
Turn the adjustable feet to
(4EA: ) with supplied wrench.
set the appliance horizontally.
Keep the transit bolts and
wrench for future use.
Insert the 4 caps provided
into the hole.
The appliance goes up by
rotating the feet clockwise.
The appliance comes down by
rotating the feet counter-
clockwise.
4. INSTALLATION
7
1
High
Low
REMOVE
THE TRANSIT BOLTS
INSTALL THE APPLIANCE ON
FLAT AND FIRM SURFACE
ADJUST THE
HORIZONTAL
HOW TO CONNECT INLET HOSE
Check that the rubber washer is inside of the
valve connector.
Connect the inlet hose firmly to prevent leak.
CONNECT DRAIN HOSE
CONNECT POWER PLUG
8
Make sure that the hose is not twisted.
The drain hose should be placed under 100cm from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices,
It may be the cause of a fire.
Avoid submerging the end of the hose.
TEST OPERATION
9
Connect the power plug to
In case of Coloureds program.
the outlet.
Connect the inlet hose.
Preparation for
Press the power button.
Press the Start/Pause
washing.
button.
Press the button TEMP
Check if the drum rotates
Check if water is supplied
and the present temperature
clockwise and
through the detergent
will be displayed.
counterclockwise.
dispenser.
Power off and then power on.
Check if the door can be
opened after door lock lamp
Check if the door can be
opened after door lock lamp
turns off.
Turn off Spin and Temp after
pressing the Start/Pause button
and start the machine again.
Check drain and Spin.
pressing the Start/Pause button
and start the machine again.
Check drain and Spin.
If SVC is needed during check,
remove the remaining water by
pulling out the hose cap.
remove the remaining water by
pulling out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
Click on the first or last page to see other WM-1175FHB service manuals if exist.