LG WFT85B31EPT Service Manual ▷ View online
4-2. DIAGRAMA DE CABLEADO
B) Series WFT75B30(1)A(B) / WFT85B30(1)D(E) / WFT85B31EHT
WFT85B31EPT
29
4-2. WIRING DIAGRAM
A)Series WFT60A30(1)A(B,C) / WFT65A30(1)D(E,F)
WF-750
30
4-3. PROGRAM TIME CHART
1) Series WFT60A30(1)A(B,C) / WFT65A30(1)D(E,F) / WFT70A30(1)D(E,F)
!"
Contents of changed algorithm by the sensor
Algorithm change :
The algorithm is automatically changed to operate at the optimum condition according to the condition detected by the sensor
.
LED Display
Orange
Green
Red
W
ash Condition
Low T
emperature
High Hardness Little Detergent
Moderate Condition
High T
emperature
Low Hardness Much Detergent
Change Factor
W
ash time
W
ash time
W
ash pattern (Off time)
Spin time Rinse w
. level
Rinse times
Change Level
Max +8 min.
Max -4 min. Max +0.2 sec. Max +2 min. Max -0.2kHz Deep rinse addition
31
4-3. T ABLA DE TIEMPO DE PROGRAMAS
2) Series WFT75B30(1)A(B) / WFT85B30(1)D(E) / WFT85B31EHT /
WFT85B31EPT
Contents of changed algorithm by the sensor
Algorithm change :
The algorithm is automatically changed to operate at the optimum condition according to the condition detected by the sensor
.
LED Display
Orange
Green
Red
W
ash Condition
Low
Temperature
High Hardness Little Detergent
Moderate Condition
High
Temperature
Low Hardness Much Detergent
Change Factor
W
ash time
W
ash time
W
ash pattern (Off time)
Spin time Rinse w
. level
Rinse times
Change Level
Max +8 min.
Max -4 min. Max +0.2 sec. Max +2 min. Max -0.2kHz Deep rinse addition
32
4-4. ADJUSTMENT
1) Brake lever adjustment
• Shown as in the figure, untighten the adjustment
screw to keep clearance less than 1.9°æ0.1mm
between the tip and the brake lever.
And turn on the lock nut then paint it red.
• Painting part is adjusted in factory, it does not
need adjusting.
• Adjust the screw properly if the brake doesn't
work during spin.
CAUTION
2) Keeping clearance
• Keep the clearance about 2.0~3.5mm between
brake lever and P.V link as shown in the figure.
• Clutch pulley must be turning to one side P.V
Link is pulling the brake Lever.
• Clutch pulley must be turning to the left and the
right when P.V Linke does not pull the brake
Lever.
CAUTION
3) V-belt adjustment
• Adjust the motor pulley by pushing the motor like
arrow , to make V-belt tension parallel when
pushed at the point of arrow .
• When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
CAUTION
Click on the first or last page to see other WFT85B31EPT service manuals if exist.