DOWNLOAD LG WF-S1117TT Service Manual ↓ Size: 4.6 MB | Pages: 59 in PDF or view online for FREE

Turn the power switch on by pressing WATER LEVEL+STAIN LEVEL+RESERVATION button together.

Test mode : Only I-SENSOR LED is on and display shows current sensing mode

: temperature &  conductivity sensing is disabled

: temperature sensing is enabled, but conductivity is disabled.

: temperature &  conductivity sensing is enabled

1. Press WATER LEVEL BUTTON once:       

Press WATER LEVEL BUTTON again : power off

2. Press RINSE BUTTON once: 

Press RINSE BUTTON again : power off

3. Press START/PAUSE BUTTON once:  

Press START/PAUSE BUTTON again : power off

Turn the power switch on by pressing WATER LEVEL + PROGRAM and STAIN LEVEL button together.

Initial Test mode display : All LEDs are off,except I-SENSOR LED

Display the number of TR calibration times : Display “      ” means not calibrated, “     ” for the 

first time and so on.

1. Press Program button once: Display the current Controller Group (1~26)

Program button again : Decrease the controller group by one (display the changed group)

Program button to decrease by one

2. Press START/PAUSE button once : Display the current Controller Group (1~26)  

Press START/PAUSE button again : increase the controller group by one (display the changed group)

START/PAUSE button to increase by one

The buzzer sounds if there is no controller group.

Initial operation: Press "RESERVATION" + "START/PAUSE" botton together after power on, and  press
"RESERVATION" button only again
(displaying the number of pressing button and each data every 0.5 second)

Sensor

Terminal

of Controller

• Loosening the front panel of the washing machine

and connect the sensor connecting terminal with

the terminal of the jig.

After supplying water to the washing bath, agitate

for one minute before using the jig.

Record the sensed value of the sensor attached

to the current product at Test mode.

Connect the jig, put the jig sensor into the

washing bath, and record the sensed value of the

sensor.

Determine the sensor performance by comparing

the value measured by the jig and the value

measured by the sensor attached to the product.

1 times : TR Controller Group ( 1 ~ 26 )

2 times : Check the temperature sensor codition

0  : Normal

99 : Temperature senosr’s error, 

(Stop sensing for Temperature and Hardness)

3 times : Temperature of supplied water

4 times : Increment/decrement of washing time according to temperature

5 times : Washing stream at Motor off according to temperature

6 times : The number of comparing the conductivity of washing with rinsing conductvity 

0 ~ 9 : Normal

99 : Abnormal (Stop the sensing of Hardness)

7 times : Sensored result (0 ~ FF:  hexadecimal is displayed)

.

.

.

18 times : Initial stage

A152

HOT(ORANGE)

COLD(BLUE)

HOT(ORANGE)
COLD(BLUE)

HOT(ORANGE)

HOT(ORANGE)

COLD(BLUE)

COLD(BLUE)

COLD(BLUE)

A030

A040

A052

A060

A210

A160

A270

A010

A240

A200

A190

A151

A230

A220

A160

A182

A020