LG WF-D55WSA / WF-D60WSA Service Manual ▷ View online
5-2. Connecting Water Supply Hose
● Connecting Water Supply Hose to the machine
Check to see if there is a black rubber seal inside the
connector. If not, it would cause water-leakage.
Hose
Rubber seal
Inlet valve
Connect the water supply hose to inlet valve of the
washing machine vertically.
washing machine vertically.
Connect the water supply hose to inlet valve of the
washing machine, and then lock it by turning the hose
connecting part.
washing machine, and then lock it by turning the hose
connecting part.
●Connecting Water Supply Hose to water tap
Separate connector from the Water Supply Hose by
pulling the Pressing Rod and the Pressing Handle that
is attached to the Water Supply Hose.
●
pulling the Pressing Rod and the Pressing Handle that
is attached to the Water Supply Hose.
●
If the tap diameter is too large , remove the guide plate
inside。
Connector
Press
Press
Water
Untighten the 4 screws on the upper connector and
turning the down connector to leave space about 3
screws between the two connectors.
turning the down connector to leave space about 3
screws between the two connectors.
If the tap diameter is too large,
remove the guide plate inside.
remove the guide plate inside.
Upper-con
Guide
3 screws
Down-con
1
1
Adjust four screws on connectors to make sure that the
two screws near the wall are in tight contact with
outside of water tap.
The screws close to the wall should
be screwed beforehand.
Water tap
Push the upper connector up till the rubber packing
can adhere completely to the tap (Attention: Do not
remove the rubber packing).
Turning two screws to be in tight contact with water
tap. Then tighten the 2 screws.
Turn the lower connector to be in tight contact with
the upper one (Loose connection will cause the water
leakage). Make sure the clearance between the two
connectors is less than 3mm.
Confirmation
<3mm
<3mm
Connector
module
module
12
Click on the first or last page to see other WF-D55WSA / WF-D60WSA service manuals if exist.