LG WD1873RDS Service Manual ▷ View online
49
FOR AUTHORIZED SERVICE TECHNICIAN
CABINET COVER
Unscrew the 5 screws from upper of the
cabinet cover.
cabinet cover.
Unscrew the screw from the filter cover.
Put a flat ( - ) screwdriver or putty knife into the
hinge slots at the bottom of the cover and pry
it out.
hinge slots at the bottom of the cover and pry
it out.
Unscrew the screw from the lower side of the
cabinet cover.
cabinet cover.
1
2
3
4
50
FOR AUTHORIZED SERVICE TECHNICIAN
Open the door.
Disassemble the clamp assembly.
Tilt the cabinet cover.
Disconnect the door switch connector.
Disassemble the clamp assembly.
Disassemble the gasket.
Lift and separate the cabinet cover.
NOTE : When assembling the
cabinet cover, connect the door switch
connector.
cabinet cover, connect the door switch
connector.
5
6
7
8
9
10
11
51
FOR AUTHORIZED SERVICE TECHNICIAN
DOOR
Open the door.
Unscrew the 4 screws from the hinge.
(Use the 8mm tool.)
(Use the 8mm tool.)
DOOR LOCK SWITCH ASSEMBLY
Open the door and remove the gasket using
the special gasket pliers.
the special gasket pliers.
Unscrew the 2 screws.
Disassemble the door upward.
NOTE
• Reconnect the connector after replacing
• Reconnect the connector after replacing
the door switch assembly.
1
3
1
2
2
52
FOR AUTHORIZED SERVICE TECHNICIAN
PUMP
Disassemble the cabinet cover.
Separate the pump hose, the bellows, the
circulation hose assembly from the pump
assembly.
Disassemble the pump assembly.
Separate the pump hose, the bellows, the
circulation hose assembly from the pump
assembly.
Disassemble the pump assembly.
HEATER
Disassemble the cabinet cover.
Separate 2 connectors from the heater.
Loosen the nut and pull out the heater.
Separate 2 connectors from the heater.
Loosen the nut and pull out the heater.
THERMISTOR
Disassemble the cabinet cover.
Unplug the white connector from the
thermistor.
Pull it out by holding the bracket of the
thermistor.
Unplug the white connector from the
thermistor.
Pull it out by holding the bracket of the
thermistor.
CAUTION
• When assembling the heater, insert the
• When assembling the heater, insert the
heater into the heater clip on the bottom of
the tub.
the tub.
• Tighten the fastening nut so the heater is
secure.
CIRCULATION
HOSE
PUMP HOSE
BELLOWS
1
2
3
1
2
3
2
3
1
2
2
3
Click on the first or last page to see other WD1873RDS service manuals if exist.