LG WD-R1112 Service Manual ▷ View online
32
① Disassemble the clamp assembly.
② Unscrew the 2 screws from cabinet cover.
③ Unscrew the screw from filter cover.
④ Put a flat ( - ) screwdriver or putty knife into
the both sides of the filter cover, and pull it
out.
out.
⑤ Unscrew the 2 screws from the lower side of
the cabinet cover.
⑥ Unscrew the 2 screws from upper part of the
cabinet cover.
GASKET ASSEMBLY
33
⑦ Disassemble the clamp assembly.
⑧ Remove dry gasket clamp by loosening the
screw.
⑨ When reassembling the gasket, put the drain
hole of the gasket downward.
Drain Hole
Tub Gasket
Clamp
Clamp
34
① Disassemble the back cover.
② Remove the bolt.
③ Pull out the Rotor.
③ Unscrew the 2 screws from the tub bracket.
④ Remove the 6 bolts on the stator.
⑤ Unplug the 2 connectors from the stator.
⑥ Disassemble the damper hinges from the tub
and base.
⑦ Separate the dampers.
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
Rotor
Bolt
Friction
Damper
Damper
Hinge
(Damper)
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER)
HOW TO ASSEMBLE THE MOTOR
※
※ NOTE
Once removed, replace the damper pin with new
one.
Once removed, replace the damper pin with new
one.
① Disassemble the cabinet cover.
② Separate the pump hose and the bellows from
the pump assembly.
③ Disassemble the pump assembly in arrow
direction.
① Disassemble the back cover.
② Separate 2 connectors from the heater.
③ Loosen the nut and pull out the heater.
① Disassemble the back cover.
② Unplug the white connector from the
thermistor.
③ Pull it out by holding the bracket of the
thermistor.
Washing
Heater
Heater
Nut
Ring Terminal
PUMP
HEATER
THERMISTOR
35
C
CA
AU
UTTIIO
ON
N
• When assembling the heater, insert the heater
into the heater clip on the bottom of the tub.
• Tighten the fastening nut so the heater is
secure.
!
Click on the first or last page to see other WD-R1112 service manuals if exist.