LG WD-R1028UDS Service Manual ▷ View online
33
①
① Unscrew the 4 screws from upper of the canbinet
cover.
②
② Unscrew the screw from filter cover.
①
① Put a flat ( - ) screwdriver or putty knife into the both
sides of the filter cover, and pull it out.
①
① Unscrew the screw from the lower side of the cabinet
cover.
①
① Unscrew the 2 screws from the lower of the DECO
PANEL.
②
② Unscrew the 4 screws from the back of the DECO
PANEL.
③
③
Pull out the DECO PANEL
34
⑤
⑤ Open the door.
⑥
⑥ Disassemble the clamp assembly.
⑦
⑦ Tilt the cabinet cover.
⑧
⑧ Disconnect the door switch connector.
※
※ NOTE: When assembling the CABINET
COVER, connect the connector.
⑨
⑨ Lift and separate the cabinet cover.
⑩
⑩ Disassemble the clamp assembly.
⑪
⑪ Disassemble the Gasket.
35
DOOR
DOOR LOCK SWITCH ASSEMBLY
HOW TO ASSEMBLE THE MOTOR
①
① Open the door.
②
② Remove the two screws from the Hinge.
※ When removing the Door Assembly, it is necessory
to hold the break is inner of the cabinet cover.
①
① Open the door and disassemble the CLAMP
ASSEMBLY.
②
② Unscrew the 2 screws.
※
※ Be careful! The door is heavy.
※
※ NOTE
• Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
36
PUMP
Washing
Heater
Heater
Ring Terminal
Nut
HEATER
THERMISTOR
①
①
Disassemble the cabinet cover.
②
②
Separate the pump hose, the bellows
and the circulation hose assembly from the
pump assembly.
pump assembly.
③
③
Disassemble the pump assembly in arrow
direction.
①
①
Disassemble the cabinet cover.
②
②
Separate 2 connectors from the heater.
③
③
Loosen the nut and pull out the heater.
①
①
Disassemble the cabinet cover.
②
②
Unplug the white connector from the thermistor.
③
③
Pull it out by holding the bracket of the
thermistor.
※
※ CAUTION
• When assembling the heater, insert the
heater into the heater clip on the bottom of
the tub.
the tub.
• Tighten the fastening nut so the heater is
secure.
Click on the first or last page to see other WD-R1028UDS service manuals if exist.