LG WD-K600W Service Manual ▷ View online
41
2 Push out PANEL ASSEMBLY, CONTROL after
Push the hook( , ) below.
1 The plate assembly(Top) is disassembled.
2 Pull out the drawer and unscrew 2 screws.
2 Pull out the drawer and unscrew 2 screws.
1 Two screws is unscrewed.
3 Unscrew the screws from the lower cover.
2 The cabinet cover clamp is removed by
special jig for service and the gasket is
released.
released.
3 Two screws are unscrewed.
4 Unscrew all the screws on the upper and
lower sides of the CABINET COVER.
1 2
3 Lift the side the Control Panel Assembly and
pull it out
CABINET COVER
42
• Just check cut-off.
• Check the operating time.
• Check the operating time.
* Door Locking time :
1~8
sec.
Check the time between from
input the power to parts
move up, then Door locked.
input the power to parts
move up, then Door locked.
1
1
1 Lift and separate the cabinet cover.
1 The cabinet cover clamp is removed and the
gasket is released.
2 Two screws are unscrewed.
3 The Door Lock S/W is disconnected form the
3 The Door Lock S/W is disconnected form the
wiring connector and the strap.
NOTE: When assembling the CABINET
COVER, connect the Door S/W connector.
COVER, connect the Door S/W connector.
SWITCH ASSY, DOOR LOCK
43
• V ~ U (8~11
Ω)
• U ~ W (8~11
Ω)
• W ~ V (8~11
Ω)
Motor Stator
U V W
Hall Sensor
Ha
Hb
Common
• Common ~ Ha (5~15k
Ω)
• Common ~ Hb (5~15k
Ω)
1 Remove the back cover.
2 After loosening the bolt, Rotor, pull out the
2 After loosening the bolt, Rotor, pull out the
rotor.
1 Remove the 6 bolt from the stator.
2 Disconnect the 2 connectors.
2 Disconnect the 2 connectors.
1 Remove the hinges (Damper) at the Tub.
3 The hinge at the base is pulled off.
(To arrow direction)
2 The Hinge(Damper) at the base is pulled off
pressing on the snaps at the sharp end.
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
44
1 Remove pump outlet hose.
2 Remove tub pump bellows.
2 Remove tub pump bellows.
1 Loosen the nut.
2 Remove washing heater by pulling out.
2 Remove washing heater by pulling out.
When assembling the washing heater, insert
the heater to heater clip on the bottom of tub
and check the position of wire color.
the heater to heater clip on the bottom of tub
and check the position of wire color.
3 Remove cap(Remaining Hose).
4 Disconnect the wiring.
5 Three screws are unscrewed from the cabinet.
6 Remove the pump to arrow direction.
4 Disconnect the wiring.
5 Three screws are unscrewed from the cabinet.
6 Remove the pump to arrow direction.
PUMP
HEATER
• Rating : 240V 50Hz
• Resistant : 162~176
• Resistant : 162~176
Ω
< Heater for Washing>
• Rating : 230V 2000W
• Resistant : 24.5~28.5
• Rating : 230V 2000W
• Resistant : 24.5~28.5
Ω
CAUTION
Click on the first or last page to see other WD-K600W service manuals if exist.