DOWNLOAD LG WD-90MFD Service Manual ↓ Size: 6.32 MB | Pages: 45 in PDF or view online for FREE

① Open the door completely.

② Remove the two screws from the hinge.

※ When removing the Door Assembly, it is

necessary to hold the Bracket that is inner of
the Cabinet Cover.

① Take apart the CLAMP ASSEMBLY (cabinet).
② Unscrew 2 screws from the CABINET COVER.
③ Open the lower cover cap and unscrew 1 screw inside
④ Take apart the LOWER COVER.

① Disassemble the CONTROL PANEL ASSEMBLY.

(Refer to page 29)

② Unscrew all the screws on the upper and lower sides of

the CABINET COVER.

① Take apart the tub CLAMP ASSEMBLY
② Make sure that the drain hole of the GASKET is put

beneath when reassembling the GASKET.

※Refer to the arrow mark on the TUB COVER.

① Remove the back cover.

② After loosening the bolt, Rotor, pull out the

rotor.

① Remove the 6 bolt from the stator.

② Disconnect the 2 connectors.

① Remove the bolts at the Tub.

② The Hinge(Damper) at the base is pulled off

pressing on the snaps at the sharp end.

③ The hinge at the base is pulled off.

(To arrow direction)

Rotor

Bolt

Hinge,
Damper

Damper

(ROTOR ASSEMBLY)

(STATOR ASSEMBLY)

(FRICTION DAMPER)

① Remove pump outlet hose.

② Remove tub pump bellows.

③ Remove cap(Remaining Hose).

④ Disconnect the wiring.

⑤ Three screws are unscrewed from the cabinet.

⑥ Remove the pump to arrow direction.

① Loosen the nut.

② Remove washing heater by pulling out.

When assembling the washing heater, insert
the heater to heater clip on the bottom of tub.

① Pull it out by holding the thermistor bracket.

If holding the wire and pulling out it, it may be

broken.

Pump Outlet Hose

Tub Pump 
Bellows

CAUTION

① The cabinet cover clamp is removed and the

gasket is released.

② Two screws are unscrewed.

③ The door lock S/W is disconnected form the

wiring connector and the strap.

① Remove washing heater.

② Remove the foreign object(wire,coin,etc) by

inserting long bar in the hole.