DOWNLOAD LG WD-80154S Service Manual ↓ Size: 2.92 MB | Pages: 34 in PDF or view online for FREE

3. PARTS IDENTIFICATION

Time Save

Crease Care

Hot/Cold (2EA)

Cold (1EA)

Wrench

ACCESSORIES

Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly  instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O·K or NOT.

STANDARD INSTALLATION

The appliance should be installed as follows.

REMOVE THE TRANSIT 

INSTALL THE  APPLIANCE

ADJUST THE 

BOLTS

ON FLAT AND FIRM SURFACE

HORIZONTAL

• Remove the transit bolts

• Turn the adjustable feet to

(4EA:①) with supplied wrench. 

set the appliance horizontally.

• Keep the transit bolts and  

wrench for future use.

• Insert the 4 caps provided 

into the hole.

• The appliance goes up by 

rotating the feet clockwise. 

• The appliance comes down by

rotating the feet counter-

clockwise.

4. INSTALLATION 

1

HOW TO CONNECT INLET HOSE

• Check that the rubber washer is inside of the

valve connector.

• Connect the inlet hose firmly to prevent leak.

CONNECT DRAIN HOSE

CONNECT POWER PLUG

• Make sure that the hose is not twisted.

※ The drain hose should be placed under 100cm from the floor.

• Connect the power plug to the wall outlet.

•  Avoid connecting several electric devices, 

It may be the cause of a fire.

• Avoid submerging the end of the hose.

TEST OPERATION

• Connect the power plug to

• In case of cotton program.      

the outlet.

• Connect the inlet hose.   

Preparation for 

Press the power button.

Press the START / PAUSE

washing.

button.

• Press both Pre Wash and Time

Delay button simultaneously the

present temperature will be displayed.

• Check if the drum rotates clockwise

and counterclockwise.

• Check if water is supplied through the

detergent dispenser.

• Power off and  then power on.
• Check if the door can be 

opened after Door Lock lamp

turns off.

• Power off and then power on.

Turn on Spin lamps after
pressing the Start / Pause button
and Start the machine again.

• Check drain and spin.

• If SVC is needed during 

check, remove

the remaining water by pulling 

out the hose cap.

Check the water heating.

Check automatic reverse

Check the water supply.

turn.

Check drain and spin 

Power off and open the 

Water removal 

door