LG WD-1480ADP5 Service Manual ▷ View online
33
Pre Wash
(Powder)
Main Wash
(Powder)
Only
softener
Clean the drawer and dispenser.
Check point
YES
Water Leak
Is detergent & softener put in
the correct compartment of the drawer?
NO
Put it in the
Correct Position
.
Replace the
Dispenser Tray
.
Reference (Amount of Detergent & Softener)
Detergent
NO!!
OK!!
Is the
Dispenser Tray
Damaged or warped?
1. Water Leak from Dispenser
Is the
Detergent
caked or hardened?
Softener
YES
YES
NO
34
NO
2. Water Leak from Dispenser
Are the gasket (seal)
and door cleaned regularly?
Is the door or gasket damaged?
Are the inlet hoses loose or cracked/split?
Replace the damaged parts.
Replace the
Inlet Hoses
.
Clean the periphery of
Gasket
and
Door
regularly.
3. Unknown – Water on Floor
YES
Is the washer horizontal ?
Adjust the height of washing machine to be kept
horizontally. (Page 7)
NO
Are the drain filter and manual
drain hose open?
YES
NO
Check!!
Turn the filter cap clockwise to close.
YES
YES
NO
35
9. DISASSEMBLY INSTRUCTIONS
Disassemble and repair the parts after pulling out power cord from the outlet.
1 Unscrew the screws on the top plate.
3 The cover(Inner) is disassembled.
2 The plate assembly(Top) is pulled back and
then upward to arrow direction.
1 Pull out the drawer and unscrew 2 screws.
2 Lift the side the Control Panel Assembly and
pull it out
1 Two screws is unscrewed.
2 Push out PANEL ASSEMBLY, CONTROL after
Push the hook below.
1 The PWB assembly(Display) is disconnected.
2 When 7 screws are unscrewed on the PWB
insulator and the PWB assembly(Display) is
disassembled from the PWB insulator.
disassembled from the PWB insulator.
CONTROL PANEL
36
1 The back cover is removed.
2 One screw is unscrewed.
3 Pull the PWB assembly(Main) to arrow
direction
4 Two screws is unscrewed.
5 The cover of PWB assembly(Main) is
removed.
6 Disconnect connector from the wiring.
PWB ASSEMBLY(MAIN)
1 The plate assembly(Top) disassembled.
2 The cover of PWB assembly(Power) is
removed.
(Push the hook bellow.)
(Push the hook bellow.)
4 Disconnect connector from the PWB.
5 Two screw is unscrewed.
PWB ASSEMBLY(POWER)
1 The plate assembly(Top) are disassembled.
3 Two screws are unscrewed.
2 Pull the drawer to arrow direction.
1 The hose clamps and the hose are
disassembled.
2 The ventilation bellows are disassembled on
the tub.
DISPENSER ASSEMBLY
Click on the first or last page to see other WD-1480ADP5 service manuals if exist.