LG WD-14316RD Service Manual ▷ View online
32
① Disassemble the clamp assembly.
② Unscrew the 2 screws from cabinet cover.
③ Unscrew the screw from filter cover.
④ Put a flat ( - ) screwdriver or putty knife into
the both sides of the filter cover, and pull it
out.
out.
⑤ Unscrew the 2 screws from the lower side of
the cabinet cover.
⑥ Unscrew the 2 screws from upper part of the
cabinet cover.
GASKET ASSEMBLY
33
⑦ Disassemble the clamp assembly.
⑧ Remove dry gasket clamp by loosening the
screw.
⑨ When reassembling the gasket, put the drain
hole of the gasket downward.
Drain Hole
Tub Gasket
Clamp
Clamp
34
① Disassemble the back cover.
② Remove the bolt.
③ Pull out the Rotor.
③ Unscrew the 2 screws from the tub bracket.
④ Remove the 6 bolts on the stator.
⑤ Unplug the 2 connectors from the stator.
⑥ Disassemble the damper hinges from the tub
and base.
⑦ Separate the dampers.
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
Rotor
Bolt
Friction
Damper
Damper
Hinge
(Damper)
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER)
HOW TO ASSEMBLE THE MOTOR
NOTE
Once removed, replace the damper pin with new
one.
one.
① Disassemble the cabinet cover.
② Separate the pump hose and the bellows from
the pump assembly.
③ Disassemble the pump assembly in arrow
direction.
① Disassemble the back cover.
② Separate 2 connectors from the heater.
③ Loosen the nut and pull out the heater.
① Disassemble the back cover.
② Unplug the white connector from the
thermistor.
③ Pull it out by holding the bracket of the
thermistor.
Washing
Heater
Heater
Nut
Ring Terminal
PUMP
HEATER
THERMISTOR
35
• When assembling the heater, insert the heater
into the heater clip on the bottom of the tub.
• Tighten the fastening nut so the heater is
secure.
!
Click on the first or last page to see other WD-14316RD service manuals if exist.