LG WD-1410RD / WD-1410RD5 Service Manual ▷ View online
45
9-5. INLET VALVE ASSEMBLY
Depending on the cycle and water temperature, the controller will energize the hot or cold
water valve solenoids to meet the selected water temperature.
After pull out the connector of defective valve, check the resistance.
Test points
(1)-(2)
Result
0.8-1.2 kΩ
!
"#
"#
#
#
$ %
$ %
$ %
$ % !
#
&
'(
%
)
&
)
%
$
$
%
)
$
%
)
&
)
%
$
&
)
%
$
&
)
%
$
*+,
* All load circuits in wiring diagramare all the same.
*$, *%,
*$, *%,
*$, *%,
*$, *%,
46
10. DISASSEMBLY INSTRUCTIONS
Disassemble and repair the parts after pulling out power cord from the outlet.
1 Unscrew the screws on the top plate.
3 The cover(Inner) is disassembled.
2 The plate assembly(Top) is pulled back and
then upward to arrow direction.
1 Pull out the drawer and unscrew 2 screws.
2 Lift the side the Control Panel Assembly and
pull it out
1 Two screws is unscrewed.
2 Push out PANEL ASSEMBLY, CONTROL after
Push the hook below.
1 The PWB assembly(Display) is disconnected.
2 When 7 screws are unscrewed on the PWB
insulator and the PWB assembly(Display) is
disassembled from the PWB insulator.
disassembled from the PWB insulator.
CONTROL PANEL
47
1 The back cover is removed.
2 One screw is unscrewed.
3 Pull the PWB assembly(Main) to arrow
direction
4 Two screws is unscrewed.
5 The cover of PWB assembly(Main) is
removed.
6 Disconnect connector from the wiring.
PWB ASSEMBLY(MAIN)
1 The plate assembly(Top) disassembled.
2 The cover of PWB assembly(Power) is
removed.
(Push the hook bellow.)
(Push the hook bellow.)
4 Disconnect connector from the PWB.
5 Two screw is unscrewed.
PWB ASSEMBLY(POWER)
1 The plate assembly(Top) are disassembled.
3 Two screws are unscrewed.
2 Pull the drawer to arrow direction.
1 The hose clamps and the hose are
disassembled.
2 The ventilation bellows are disassembled on
the tub.
DISPENSER ASSEMBLY
48
VALVE (STEAM)
VALVE (PRE-WASH)
VALVE (NORMAL-WASH)
VALVE (HOT)
1 Disconnect the wiring connector.
1
2
3
4
2 Remove the valve by two screws of the valve
holder.
• Rating : 220/240V 50/60Hz
• Resistant : 3.5~4.5kΩ
• Resistant : 3.5~4.5kΩ
When reconnecting the connector
VALVE
(HOT) is option.
1 Open the door completely.
2 Remove the three screws from the hinge.
When removing the Door Assembly, it is
necessary to hold the Bracket that is inner of
the Cabinet Cover.
necessary to hold the Bracket that is inner of
the Cabinet Cover.
First, prepare a bucket to put in the remained
water.
water.
Pull it out from hose.
VIOLET/BLACK-BLACK
WHITE/BLACK-BLACK
GRAY/BLACK
BLACK/WHITE
INLET VALVE
DOOR
Removing method of remained water
4
Click on the first or last page to see other WD-1410RD / WD-1410RD5 service manuals if exist.