LG WD-1260FHD Service Manual ▷ View online
8
HOW TO CONNECT INLET HOSE
Check that the rubber washer is inside of the
valve connector.
Connect the inlet hose firmly to prevent leak.
CONNECT DRAIN HOSE
CONNECT POWER PLUG
Make sure that the hose is not twisted.
The drain hose should be placed under 100cm from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices,
It may be the cause of a fire.
Avoid submerging the end of the hose.
9
TEST OPERATION
Start/Pause
Connect the power plug to
the outlet.
In case of coloureds program.
Connect the inlet hose.
Preparation for
Press the power button.
Press the Start/Pause
washing.
button.
Press the Temp. button
Check if the drum rotates
Check if water is supplied
and the present temperature will
clockwise and counterclockwise.
through the detergent dispenser.
be displayed.
Power off and then power on.
Check if the door can be
opened after 3 minutes.
Check if the door can be
opened after 3 minutes.
Turn off Wash and Rinse after
pressing the Start/Pause button
pressing the Start/Pause button
and start the machine again.
Check drain and spin.
If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
10
5. OPERATION
LED display
Display the estimated remaining time
(Hour : Minute) to finish.
In case of abnormal operation, error
indications are displayed.
indications are displayed.
( )
See troubleshooting guide.
Wash program selector
7 program can be set depending on the type of the laundry.
If the power button is pressed, Coloureds program is
automatically set.
By turning the dial, [Coloureds
If the power button is pressed, Coloureds program is
automatically set.
By turning the dial, [Coloureds
Synthetic
Delicate
Wool
Rapid
Whites
Whites-Eco ]can be selected.
(The opposite is possible)
Start/Pause button
Use the button to start or pause wash cycle.
The power turns off automatically 4 minutes
after the pause button is pressed.
The power turns off automatically 4 minutes
after the pause button is pressed.
(Power) button
Press the button to turn power on and off.
Press the button to cancel the delay finish.
Press the button to cancel the delay finish.
Whites-Eco
If you want to get the
almost same effect as that
in 95˚C whites program with
less energy consumption,
select White-Eco program.
almost same effect as that
in 95˚C whites program with
less energy consumption,
select White-Eco program.
,
,
,
,
,
,
,
,
[WD(M)-1060F(H)D / 1065F(H)D / 1260F(H)D / 1265F(H)D / 1460F(H)D / 1465F(H)D]
11
Water temperature
selector
selector
Press the button to select
water temperature.
The water temperature
water temperature.
The water temperature
[40 C
60 C
Cold
30 C] can be
selected in Coloureds or
Synthetic.
Synthetic.
95 C is selected for
Whites only.
By pressing the button
while operating the
washer, the present
temperature is displayed.
Whites only.
By pressing the button
while operating the
washer, the present
temperature is displayed.
Child - Lock
Child Lock system can be set and canceled by pressing
and holding both [Wash] and [Rinse] button simultaneously
more than 2 seconds.
Once Child Lock is set, all buttons are inoperable.
Child Lock system can be set anytime even during Power-
off and operation.
It is automatically cancelled when an operational error
occur.
and holding both [Wash] and [Rinse] button simultaneously
more than 2 seconds.
Once Child Lock is set, all buttons are inoperable.
Child Lock system can be set anytime even during Power-
off and operation.
It is automatically cancelled when an operational error
occur.
Time Delay
Press the button when delayed washing is needed.
When the button is pressed, is displayed,
maximum delay of hours can be set.
Each press advances time delay by the hour.
Use [Power] button to cancel [Time Delay]
[Time Delay] means the time required from the present
to the completion of washing.
When the button is pressed, is displayed,
maximum delay of hours can be set.
Each press advances time delay by the hour.
Use [Power] button to cancel [Time Delay]
[Time Delay] means the time required from the present
to the completion of washing.
For manual wash, rinse and spin
speed
speed
Use these buttons to change
wash/rinse/spin.
When lamp is off, no selection has been
made.
Prewash is available for coloureds, whites,
white-eco, and synthetic.
wash/rinse/spin.
When lamp is off, no selection has been
made.
Prewash is available for coloureds, whites,
white-eco, and synthetic.
Rinse hold
If you desire to leave fabrics in the
machine without spinning after rinse to
prevent wrinkling, you may select
rinse Hold by pressing the Rinse
button.
To drain and spin, press the Rinse
button to turn off the Rinse Hold lamp.
machine without spinning after rinse to
prevent wrinkling, you may select
rinse Hold by pressing the Rinse
button.
To drain and spin, press the Rinse
button to turn off the Rinse Hold lamp.
Click on the first or last page to see other WD-1260FHD service manuals if exist.