LG WD-12360SD Service Manual ▷ View online
Before servicing ask the customer what the trouble is.
Check the adjustments. (Power supply :220~240V, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.
Check the adjustments. (Power supply :220~240V, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.
STANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT
INSTALL THE APPLIANCE
ADJUST THE
BOLTS
ON FLAT AND FIRM SURFACE
HORIZONTAL
Remove the transit bolts
Turn the adjustable feet to
(4EA: ) with supplied wrench.
set the appliance horizontally.
Keep the transit bolts and
wrench for future use.
Insert the 4 caps provided
into the hole.
The appliance goes up by
rotating the feet clockwise.
The appliance comes down by
rotating the feet counter-
clockwise.
4. INSTALLATION
7
1
High
Low
HOW TO CONNECT INLET HOSE
Check that the rubber is the inside of valve connector.
Connect inlet hoses firmly to prevent leak.
CONNECT DRAIN HOSE
CONNECT POWER PLUG
8
Make sure that the hose is not twisted.
The drain hose should be placed under 100cm from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices,
It may be the cause of a fire.
Avoid submerging the end of the hose.
TEST OPERATION
9
Connect the power plug to
In case of cotton program.
the outlet.
Connect the inlet hose.
Preparation for
Press the power button.
Press the START/PAUSE
washing.
button.
Press both Time Delay and
Pre Wash buttons simultaneously
the present temperature will be
displayed.
Check if the drum rotates clockwise
and counterclockwise.
Check if water is supplied through
the detergent dispenser.
Power off and then power on.
Check if the door can be
opened after Door Lock lamp
Check if the door can be
opened after Door Lock lamp
turns off.
Power off and then power on.
Turn on Spin lamps after
pressing the Start/Pause button
and Start the machine again.
Check drain and spin.
Turn on Spin lamps after
pressing the Start/Pause button
and Start the machine again.
Check drain and spin.
If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
Baby Care
Cotton
Eco
Synthetic
Quick 30
Rinse+Spin
Start/Pause
Bio Care
Bedcover
Delicate
Hand Wash/
Wool
Wool
10
5. OPERATION
LED display
Display the estimated remaining time (Hour : Minute)
to finish.
In case of abnormal operation, error indications are
displayed.
( )
to finish.
In case of abnormal operation, error indications are
displayed.
( )
See troubleshooting guide.
Eco
It is possible in cotton
course when 60 C
course when 60 C
Start/Pause button
Use the button to start or pause wash
cycle.
The power turns off automatically 4 minutes
after the pause button is pressed.
cycle.
The power turns off automatically 4 minutes
after the pause button is pressed.
Spin
WD-1036(0~9)SD/1036(0~9)ND/1036(0~9)TD
No Spin/No Drain/400/600/800/900/1000
No Spin/No Drain/400/600/800/900/1000
WD-1236(0~9)SD/1236(0~9)ND/1236(0~9)TD
No Spin/No Drain/400/600/800/1000/1200
No Spin/No Drain/400/600/800/1000/1200
Wash program selector
10 programs can be set
depending on the type of the
laundry.
If the power button is pressed,
all lamps are on
By turning the dial, [Cotton–Eco
Synthetic–Quick 30–
Rinse+Spin–Hand Wash/Wool–
Delicate–Bedcover–Bio Care–
Baby Care] can be selected.
(The opposite is possible)
depending on the type of the
laundry.
If the power button is pressed,
all lamps are on
By turning the dial, [Cotton–Eco
Synthetic–Quick 30–
Rinse+Spin–Hand Wash/Wool–
Delicate–Bedcover–Bio Care–
Baby Care] can be selected.
(The opposite is possible)
Click on the first or last page to see other WD-12360SD service manuals if exist.