LG WD-12320RDK Service Manual ▷ View online
■ HOW TO CONNECT INLET HOSE
Check that the rubber packing is inside of the
valve connector.
Connect the inlet hose firmly to prevent leak.
■ CONNECT DRAIN HOSE
■ CONNECT POWER PLUG
8
· Make sure that the hose is not twisted.
※ The drain hose should be placed under 100cm from the floor.
· Connect the power plug to the wall outlet.
· Avoid connecting several electric devices,
It may be the cause of the fire.
· Avoid submerging the end of the hose.
TEST OPERATION
9
Connect the power plug to
the outlet.
In case of Coloreds program.
Connect the inlet hose.
Preparation for
Press the POWER button.
Press the Start/Pause
washing.
button.
·Press the Temp. button
·Check if the drum rotates
·Check if water is supplied
and the present temperature will
clockwise and counterclockwise.
through the detergent dispenser.
be displayed.
·Power off and then power on.
·Check if the door can be
·Check if the door can be
opened after 3 minutes.
·Turn off Wash and Rinse after
pressing the Start/Pause button
and start the machine again.
and start the machine again.
·Check drain and spin.
·If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
10
5. OPERATION
• Use this button to turn the
power
On/Off.
On/Off.
• Rotate the Cycle selector
knob to select the cycle
designed for different
types of fabric and soil
levels.
designed for different
types of fabric and soil
levels.
• Use this option to prevent unwanted use of the washer.
Press and hold PRE WASH button for 3 seconds to
lock/unlock control.
lock/unlock control.
• When Child lock is set, CHILD LOCK lights and all
buttons are disabled except the Power button. You
can lock the washer while it is operating.
can lock the washer while it is operating.
• Prewash: Use this option for loads that need pretreatment. It adds 16
minutes prewash and drain.
• Rinse+Spin: Use this option to rinse and then spin.
• Soak: Use this mode to wash normal clothes or think and heavy
clothes which are excessively dirty.
• Spin Only: When you want Spin only, select this option.
• Dry only: When you want Dry only, select this option.
• Use this button to Start/
Stop the washer.
• This display shows:
a) the estimated time remaining in the
cycle when operating.
b) an error code when an error has been
detected.
11
• TIME SAVE
• DRY Button
• Rinse, Spin, Temp. Button
• TIME DELAY
• This option can be used to
reduce the time of a wash
program
program
• To use this option press
the Time Save button
once before wash
program is start.
once before wash
program is start.
• Allows the start of any cycle
to be delayed for 3~19
hours.
hours.
• Select a water temperature based on the type
of load you are washing.
• To change the spin speed, press the Spin
Speed button repeatedly to cycle through
available options.
available options.
• To change the soil level, press the Soil Level
button repeatedly until the desired setting is
on.
on.
• These lights show which portion
of the cycle the washer is
operating.
operating.
• Dry programs selected by pressing the Dry button.
• By pressing the button [Time-Very-Cupboard-Iron-
Low Temp.] can be selected.
Click on the first or last page to see other WD-12320RDK service manuals if exist.