LG WD-12230TB / WD-12231TB Service Manual ▷ View online
3. PARTS IDENTIFICATION
6
Hot/Cold (2EA)
Cold (1EA)
Wrench
Power plug
Control panel
Door
Lower cover
Adjustable feet
(For detergent and
fabric softener)
Drawer
Drum
Lower cover cap
Drain plug
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agents
or a similarly qualified person in
order to avoid a hazard.
or a similarly qualified person in
order to avoid a hazard.
Drain pump filter
Wool
ool
Hand W
Hand W
ash
ash
Drain
Drain
Synthetic
Synthetic
■ACCESSORIES
Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O·K or NOT.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O·K or NOT.
■ STANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT
INSTALL THE APPLIANCE
ADJUST THE
BOLTS
ON FLAT AND FIRM SURFACE
HORIZONTAL
• Remove the transit bolts
• Turn the adjustable feet to
(4EA:①) with supplied wrench.
set the appliance horizontally.
• Keep the transit bolts and
wrench for future use.
• Insert the 4 caps provided
into the hole.
• The appliance goes up by
rotating the feet clockwise.
• The appliance comes down by
rotating the feet counter-
clockwise.
4. INSTALLATION
7
1
High
Low
■ HOW TO CONNECT INLET HOSE
• Check that the rubber washer is inside of the
valve connector.
• Connect the inlet hose firmly to prevent leak.
■ CONNECT DRAIN HOSE
■ CONNECT POWER PLUG
8
· Make sure that the hose is not twisted.
※ The drain hose should be placed under 100cm from the floor.
· Connect the power plug to the wall outlet.
· Avoid connecting several electric devices,
It may be the cause of a fire.
· Avoid submerging the end of the hose.
TEST OPERATION
9
•Connect the power plug to
•In case of cotton program.
the outlet.
•Connect the inlet hose.
Preparation for
Press the power button.
Press the START/PAUSE
washing.
button.
·Press both Pre Wash and Time
Delay button simultaneously the
present temperature will be
displayed.
present temperature will be
displayed.
·Check if the drum rotates clockwise
and counterclockwise.
·Check if water is supplied through
the detergent dispenser.
·Power off and then power on.
·Check if the door can be
·Check if the door can be
opened after Door Lock lamp
turns off.
·Turn off Wash and Rinse lamps
after pressing the Start/Pause
button and start the machine
again.
button and start the machine
again.
·Check drain and spin.
·If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
Click on the first or last page to see other WD-12230TB / WD-12231TB service manuals if exist.