LG WD-12150FB / WD-12151FB Service Manual ▷ View online
Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.
STANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT
INSTALL THE APPLIANCE
ADJUST THE
BOLTS
ON FLAT AND FIRM SURFACE
HORIZONTAL
Remove the transit bolts
Turn the adjustable feet to
(4EA: ) with supplied wrench.
set the appliance horizontally.
Keep the transit bolts and
wrench for future use.
Insert the 4 caps provided
into the hole.
The appliance goes up by
rotating the feet clockwise.
The appliance comes down by
rotating the feet counter-
clockwise.
4. INSTALLATION
7
1
High
Low
HOW TO CONNECT INLET HOSE
Check that the rubber washer is inside of the
valve connector.
Connect the inlet hose firmly to prevent leak.
CONNECT DRAIN HOSE
CONNECT POWER PLUG
8
Make sure that the hose is not twisted.
The drain hose should be placed under 100cm from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices,
It may be the cause of a fire.
Avoid submerging the end of the hose.
TEST OPERATION
9
Connect the power plug to
In case of cotton program.
the outlet.
Connect the inlet hose.
Preparation for
Press the power button.
Press the START/PAUSE
washing.
button.
Press both Pre Wash and Time
Delay button simultaneously the
present temperature will be
displayed.
Check if the drum rotates clockwise
and counterclockwise.
Check if water is supplied through
the detergent dispenser.
Power off and then power on.
Check if the door can be
opened after Door Lock lamp
Check if the door can be
opened after Door Lock lamp
turns off.
Turn off Wash and Rinse lamps
after pressing the Start/Pause
button and start the machine
again.
Check drain and spin.
after pressing the Start/Pause
button and start the machine
again.
Check drain and spin.
If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
10
5. OPERATION
LED display
Display the estimated remaining time
(Hour : Minute) to finish.
In case of abnormal operation, error
indications are displayed.
indications are displayed.
( )
See troubleshooting guide.
Eco
It is possible in cotton
course when 60 C
course when 60 C
Power button
Press the button to turn power on and off.
Press the button to cancel the time delay.
Press the button to cancel the time delay.
Start/Pause button
Use the button to start or pause wash
cycle.
The power turns off automatically 4 minutes
after the pause button is pressed.
cycle.
The power turns off automatically 4 minutes
after the pause button is pressed.
Wash program selector
8 program can be set
depending on the type of the
laundry.
If the power button is pressed,
all lamps are on
By turning the dial, [Cotton
depending on the type of the
laundry.
If the power button is pressed,
all lamps are on
By turning the dial, [Cotton
Delicate
Quick 30
Rinse + Spin
Spin
Hand
Wash
Wool
Synthetic]
can be selected.
(The opposite is possible)
(The opposite is possible)
Click on the first or last page to see other WD-12150FB / WD-12151FB service manuals if exist.